Overview
The Pro Comp Suspension ZX2117 is a rear Pro Runner monotube shock for trucks with a 3 inch lift. It fits the 2014 to 2018 Ram 2500 and the 2014 Ram 3500, in several trims.
Pro Comp uses a nitrogen gas charged monotube body that is brushed, zinc plated and clear coated. The gas charge is intended to prevent cavitation in compression and rebound, and the valving is tuned for each application.
Key features
- Rear monotube design for a 3 inch lift
- Nitrogen gas charged
- 2 inch diameter body
- Multi-stage valving tuned for each application
- Brushed zinc plated body with clear coat
- Includes rubber bushing and black polyurethane boots
Rear shock setup basics
A rear shock controls the axle’s movement under the leaf springs, so it works hard on loaded trucks and on washboard roads. When the rear is lifted, the shock sits at a different angle and length, which changes how the body moves at full travel. Confirm the body clears the spring perch, frame and any cargo rails before the truck is driven.
On a Ram with a rear lift, shocks are often replaced along with the bushings, bump stops and spring hardware. Keep the shaft clean and free of grit, since a scratch can wear the seal and let oil escape. Look for oil on the body, a knocking sound over bumps, or a rear end that keeps bouncing after a dip as signs the old shock is worn.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPZX2117 |
| Shock series | Pro Runner |
| Position | Rear |
| Body diameter | 2 in |
| Lift | 3 in |
| Charge | Nitrogen gas |
| Boots | Black polyurethane, included |
Vehicle fitment
It fits the 2014 to 2018 Ram 2500, in several trims including Big Horn, Laramie, Power Wagon and Tradesman, and the 2014 Ram 3500.
Check fit against your year, model and trim before buying, especially for Ram 1500 trucks and 2019 and later Ram 2500 and 3500 models.
Installation notes
Confirm the lift on the Ram before ordering, since this rear shock is designed for a 3 inch lift. The 2 inch body is the figure to keep in mind when checking clearance around the rear axle and the leaf springs. Include the rubber bushing and the polyurethane boot in your fit check, and confirm the shaft is undamaged before mounting.
Check the rubber bushing and the polyurethane boot are seated correctly on the shaft before the rear shock is installed. Confirm the body is clear of the leaf springs and the frame through full travel, and inspect the shock once the truck is back on the ground.
What’s included
One rear Pro Runner monotube shock with rubber bushing and black polyurethane boot under part number EXPZX2117.


















