Overview
The Pro Comp Suspension EXPPR2002 is a PRO-M SS front monotube shock for models with 0 to 1.75 inches of lift. It is sold individually and fits the 2007 to 2013 Chevrolet Silverado 1500 and the 2007 to 2013 GMC Sierra 1500.
The shock is nitrogen gas charged, and a floating piston separates the oil from the gas to reduce cavitation. The shock body holds extra oil to help dissipate heat.
Key features
- Front monotube design for 0 to 1.75 inches of lift
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Front ride height and mounts
Front ride height has a direct effect on how a shock works. A shock that is longer or shorter than the one it replaces changes the suspension angle, the steering geometry and the spring preload, so compare the old unit’s lengths before buying. On a Silverado or Sierra with little or no lift, a stock-height truck can be surprisingly sensitive to small changes in shock length.
The stem upper mount needs to seat fully in the factory bracket, with the hardware tight and free of corrosion. Check the lower loop for clean alignment and make sure the boot is not pinched. Front shocks tend to wear at the bushings and seals first, so look for oil on the body, clunking over bumps, or a truck that pulls on uneven pavement as signs the unit needs replacement. Replacing it with a matched unit helps keep both sides even.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2002 |
| Shock series | PRO-M SS |
| Position | Front |
| Extended length | 18.5 in |
| Collapsed length | 14.5 in |
| Upper mount | Stem |
| Lower mount | Loop |
| Lift | 0 to 1.75 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2007 to 2013 Chevrolet Silverado 1500 and the 2007 to 2013 GMC Sierra 1500, in several trims including LT, LTZ, SLE and SLT.
Check fit against your year, model and trim first, especially for 2014 and later trucks and 2500 HD models.
Installation notes
The 18.5 inch extended and 14.5 inch collapsed lengths should be compared with the front shock being replaced before ordering, since a longer or shorter unit changes the front ride height. The stem upper mount must match the factory mount on your Silverado or Sierra, so check the mounting hardware. Because this shock is for little or no lift, confirm the truck’s height first, and inspect the boot after installation for a clean seal.
Measure the front ride height before fitting the shock, since this unit is designed for little or no lift. Check the stem top mount for a snug fit in the factory bracket, and confirm the front shock clears the front spring and inner fender at full compression. Once installed, test the damper by hand to confirm it moves smoothly.
What’s included
One PRO-M SS front monotube shock with polyurethane boot under part number EXPPR2002.








