Overview
The Pro Comp Suspension EXPPR2121 is a PRO-M monotube shock for the 2015 Chevrolet Colorado and the 2015 GMC Canyon. It is rated for 0 to 2 inches of lift or drop, and it is sold individually.
The shock is nitrogen gas charged, with a floating piston that keeps oil and gas separate. The multi-stage valving is vehicle specific, balancing ride quality with handling on road and off road.
Key features
- Monotube design for 0 to 2 inches of lift or drop
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Choosing shock length
Monotube shocks use a single tube with a floating piston, so they handle heat well and keep consistent damping over longer runs. The nitrogen charge helps prevent foaming of the oil under hard use. The length of the shock matters because it controls how far the suspension can travel before the shock reaches its stops. Check the boot for cracks at every service.
When lift changes, shock length should be checked against the new suspension height, and a shock that is too short can bottom out or bind. Clean the mounts and the stem before installation, and look for seepage at the shaft seal after the first few drives. A torn boot lets grit reach the seal and should be replaced promptly. Shocks wear over time, so inspection at each service helps catch problems early.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2121 |
| Shock series | PRO-M |
| Position | Position is rear and front, so confirm the mounting position before ordering. |
| Extended length | 22.5 in |
| Collapsed length | 14.7 in |
| Upper and lower mount | Loop |
| Lift | 0 to 2 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2015 Chevrolet Colorado in Base, LT, WT and Z71 trims, and the 2015 GMC Canyon in Base, SL, SLE and SLT trims.
It is available for both front and rear positions. Confirm the position against the shock being replaced before ordering. Make sure the year, model and trim match before ordering.
Installation notes
Compare the 22.5 inch extended and 14.7 inch collapsed lengths with the shock being removed. The loop mounts should line up with the Colorado or Canyon’s factory brackets. Match the position to the wheel the shock came from, and check the boot and body for clearance at full travel once the truck is back on the ground.
The shock is designed for 0 to 2 inches of lift, so measure the truck’s height before ordering. Check the spring and frame for clearance at full compression.
What’s included
One PRO-M monotube shock with polyurethane boot under part number EXPPR2121.








