Overview
The Pro Comp Suspension PR2027 is a PRO-M rear monotube shock for trucks with 0 to 2 inches of lift. It fits the 1994 to 2008 Dodge Ram 1500, the 1994 to 2010 Ram 2500 and the 1994 to 2008 Ram 3500, along with later Ram 2500 and 3500 years, and it is sold individually.
The shock is nitrogen gas charged, with a floating piston that separates oil from gas. Its multi-stage valving is set for each application, and the extended length is 27.4 inches.
Key features
- Rear monotube design for 0 to 2 inches of lift
- Extended length 27.4 inches, collapsed length 17.5 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Rear ride height and load
The rear shock works with the leaf springs to control body motion over bumps and during braking. On a Ram carrying weight in the bed or pulling a trailer, the rear end sits lower, and a worn or undersized shock lets the truck bounce longer after each dip. Choosing a shock for the lift you actually run keeps the suspension working through its designed range.
When a shock is replaced, the springs and bushings are often checked at the same time, since a worn bushing can make a new shock feel loose. Look for oil on the shock body, a torn boot, or a clunk at the mounts as signs the old unit has reached the end of its service life.
- Check mounts and bushings for play
- Replace shocks in pairs on the same axle
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2027 |
| Shock series | PRO-M |
| Position | Rear |
| Extended length | 27.4 in |
| Collapsed length | 17.5 in |
| Lift | 0 to 2 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 1994 to 2008 Dodge Ram 1500, the 1994 to 2010 Dodge Ram 2500, the 1994 to 2008 Dodge Ram 3500, the 2011 to 2012 Ram 2500 and the 2014 to 2021 Ram 3500, in several trims.
Ram 1500 models from 2009 on are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Compare the 27.4 inch extended and 17.5 inch collapsed lengths with the rear shock being removed, since the Ram rear suspension depends on the length for ride height. The 0 to 2 inch lift range is the one this shock is designed for. Loop mounts should line up with the factory brackets, and the boot should be checked for clearance from the axle at full compression.
Measure the rear ride height before ordering, since the 0 to 2 inch lift range is the one this rear shock is designed for. Confirm the loop mounts line up with the factory brackets and that the boot is not pinched after installation.
Check the rear shock clears the leaf springs and the frame at full droop, and confirm the mounts are seated in the factory brackets.
What’s included
One PRO-M rear monotube shock with polyurethane boot under part number EXPPR2027.









