Overview
The Pro Comp Suspension PR2018 is a PRO-M front monotube shock for trucks with 0 to 2.5 inches of lift. It is sold individually and fits the 1999 to 2007 Chevrolet Silverado 1500 and GMC Sierra 1500, including the HD and Classic versions.
The shock is nitrogen gas charged. Its floating piston keeps the oil apart from the gas, which Pro Comp says reduces cavitation, and the shaft is 14 mm chrome hardened.
Key features
- Front monotube design for 0 to 2.5 inches of lift
- Extended length 16.5 inches, collapsed length 11.6 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
- Polyurethane shock boot included
Ride height and travel
Ride height is set mainly by the spring, but a shock that is too long or too short for its lift changes how the suspension uses its travel. A damper near the end of its stroke can bottom out on bumps, while one with too little extension can run into the stop on the other side. Measuring both ends before buying helps the new shock sit where the factory design expects it.
Dust and mud trapped against the shaft are common causes of seal failure, so wipe the exposed chrome after off-road drives. Even damping across both front wheels matters during highway lane changes and braking on uneven pavement. Pay attention to clicks or knocks from the upper mount, since a loose stem fastener can be mistaken for a bad damper.
- Listen for knocks over bumps
- Check the boot for tears
- Look for oil on the shaft or body
- Torque upper mount fasteners after the first drive
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2018 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 16.5 in |
| Collapsed length | 11.6 in |
| Upper mount | Stem |
| Lower mount | Loop |
| Lift | 0 to 2.5 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 1999 to 2007 Chevrolet Silverado 1500 and GMC Sierra 1500, the 2001 to 2003 and 2005 to 2006 Silverado and Sierra 1500 HD, and the 2007 Classic and HD Classic versions.
Match your truck’s year, model and trim against these fitment details before buying, especially for 2008 and later 1500 trucks.
Installation notes
Confirm the truck is within the 0 to 2.5 inch lift range before ordering, since the valving is tuned for it. The 16.5 inch extended and 11.6 inch collapsed lengths should be compared with the front shock being removed. The 2 inch body needs clearance against the front spring, and the stem top mount should seat in the factory bracket before the shock is loaded.
Confirm the front shock clears the front spring and the inner fender through full compression and rebound. The stem top must sit correctly in the bracket, and the 2 inch body should be checked against the spring seat before the truck is loaded. Recheck the alignment after the front suspension has settled.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2018.









