Overview
The Pro Comp Suspension PR2015 is a PRO-M front monotube shock for the 1999 to 2007 Chevrolet Silverado 1500 and the 1999 to 2007 GMC Sierra 1500. It is designed for trucks with 4 inches of lift and is sold individually.
The shock is nitrogen gas charged with a floating piston and a multi-stage disc pack with vehicle specific valving. It has a 14 mm chrome hardened shaft and a polyurethane boot.
Key features
- Front monotube design
- Extended length 20.8 inches, collapsed length 13.9 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Choosing shock length
Front shock length matters most when a truck has been lifted, because the extended and collapsed measurements set how far the front axle can travel before the shock reaches its limits. A longer shock suits a higher lift, while a shorter one keeps the stock ride height closer to factory. Measure the old shock first, both collapsed and extended, and compare those figures with the new unit before purchase.
Monotube designs with a floating piston handle heat better during sustained off-road use than a basic twin-tube body, and the nitrogen charge helps limit foaming in the oil. When replacing a front shock, check the upper stem and lower loop bushings, since worn rubber can make a new shock feel loose. Front springs that have sagged often make the new shock look like it sits too high or low, so inspect the spring before blaming the damper.
- Replace front shocks in pairs to keep damping even side to side
- Check the boot for cracks before reinstalling
- Inspect upper and lower bushings for wear
- Re-torque mounting hardware after the first drive
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2015 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 20.8 in |
| Collapsed length | 13.9 in |
| Upper mount | Stem |
| Lower mount | Loop |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 1999 to 2007 Chevrolet Silverado 1500 and GMC Sierra 1500, including Classic models for 2007.
Verify the lift height on your truck before buying, then match it to the year, model and trim you own.
Installation notes
Compare the 20.8 inch extended and 13.9 inch collapsed lengths with the front shock being removed, because the length decides how much the front ride height changes. The stem top and loop bottom mounts should match the factory hardware on your 1999 to 2007 truck. After installation, check the front alignment and confirm the shock moves freely through the full range of travel without contacting the frame.
The stem top and loop bottom mounts must match the factory hardware on the 1999 to 2007 Silverado or Sierra. Check the boot seats fully on the shaft and that the front spring has clearance from the shock body through full travel, then recheck the alignment once the truck is at ride height.
Check that the front shock is clear of the steering linkage and the brake lines at full lock.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2015.









