Overview
The Pro Comp K5089BX is a 6-inch lift kit with PRO-VST front coilovers and PRO-VST rear shocks for the 2016–2023 Toyota Tacoma. Pro Comp built it as a 6-inch suspension system for the 2016 Tacoma, with a 6 to 7 inch lift height range and shocks included.
The front uses extended steering knuckles, so the rack-and-pinion steering unit stays in its factory location. Rock-proof crossmembers are part of the design, and Pro Comp says its engineering keeps the suspension angles right through the full range of compression and extension travel without binding the ball joints.
Key features
- Extended steering knuckles that keep the rack-and-pinion steering in the factory location
- Rock-proof crossmembers for added durability
- Geometry designed to avoid ball joint binding through full compression and extension travel
- PRO-VST front coilovers and PRO-VST rear shocks, included
- Block and U-bolt rear lift with add-a-leaf hardware
Choosing the right setup
Front suspension lifts raise the truck through the knuckles and springs, which changes the angles of the steering and axle joints. Extended knuckles are a common way to keep the steering rack where the factory put it, so the tie rods stay closer to their original geometry. Owners often pair a lift like this with a steering stabilizer and fresh tie rod ends during the same job.
Look at the wheel and tire size you plan to run before buying. Bigger tires add load to ball joints and wheel bearings, so inspect those parts during the first few weeks of driving. Check the brake hoses for stretch once the truck sits at full height, and recheck the lug nuts after a short run. Asking a shop to inspect the old components before the install begins can prevent surprises.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | K5089BX |
| Suspension type | Lift kit, stage 1 |
| Lift height | 6 inches, listed range 6–7 inches |
| Front shocks | PRO-VST coilovers |
| Rear shocks | PRO-VST, included |
| Rear lift method | Block and U-bolt with add-a-leaf |
| Shocks included | Yes |
Vehicle fitment
It fits the 2016–2023 Toyota Tacoma in the Limited, SR, SR5, TRD Off-Road, TRD Pro, TRD Sport and Trail configurations.
It is made for 2016–2023 Tacoma models, not the 2005–2015 Tacoma, the 4Runner or the Tundra. Check the year and trim on your truck before buying.
Installation notes
The kit adds extended steering knuckles and rock-proof crossmembers at the front, and the lift changes driveline angles, so have the alignment and driveline angles checked after installation.
What’s included
PRO-VST front coilovers, PRO-VST rear shocks, extended steering knuckles, rock-proof crossmembers, and the rear block and U-bolt lift hardware.













