Overview
The Pro Comp K4116B is a 6-inch stage 1 coil spring lift with ES3000 front and rear shocks. It fits 1981–1989 Ford F-150 trucks and gives a lift height range of 5 to 6.99 inches.
The front uses coil springs with radius arm brackets and I beam brackets, and the rear is raised with a block and U-bolt kit. A pitman arm corrects the steering, and extended length SS brake lines are included. The shock boots are not included.
Key features
- 6-inch lift, stage 1 design
- Front coil springs with radius arm brackets
- I beam brackets
- Pitman arm steering correction
- Extended length SS brake lines
- Rear block and U-bolt lift
Setting up a 6-inch front end
A 6-inch lift is a bigger change than a small leveling kit, so the front suspension and steering both see more load. Radius arm brackets and I beam brackets take the stress of the new angles, and the pitman arm is there to keep the steering geometry from drifting. Drive shafts and CV joints run at steeper angles at this height, which is why a driveline inspection belongs on the post-install checklist.
Tire size usually goes up with a lift like this, and wheel offset needs to clear the new fender and suspension arms. Brake line length and hose routing deserve a close look, since a higher ride changes how hoses stretch at full droop. Plan to re-check every fastener after the first short drives, then again at the next service.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | K4116B |
| UPC | 614901125399 |
| Lift | 6 inches, stage 1 |
| Lift height range | 5 to 6.99 inches |
| Suspension type | Radius arm |
| Front lift | Coil springs with radius arm brackets and I beam brackets |
| Rear lift | Block and U-bolt kit |
| Steering correction | Pitman arm |
| Front shocks | ES3000 |
| Rear shocks | ES3000 |
| Brake lines | Extended length SS |
| Shock boots | Not included |
Vehicle fitment
Fits 1981–1989 Ford F-150 trucks only. Bronco models and other years are outside its coverage.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Radius arm brackets and I beam brackets change the front geometry, so set the alignment after installation. Check the extended SS brake lines for routing at the new height before the wheels are fitted.
What’s included
The kit includes front coil springs, radius arm brackets, I beam brackets, a pitman arm, extended length SS brake lines, a rear block and U-bolt kit and ES3000 front and rear shocks. Shock boots are not included.









