Overview
The Power Stop Z36-702A rear brake pads are Z36 Truck and Tow disc brake pads for 2001–2008 Dodge Ram 2500 and Ram 3500.
The Z36 line is meant for trucks and SUVs that run at higher gross vehicle weights, such as rigs that tow or carry heavy loads. Compared with OE pads, Power Stop reports a 17 percent higher coefficient of friction for this compound.
Key features
- Carbon and ceramic friction formula
- Thermal scorched finish
- Chamfered and slotted like the OE pads
- Powdercoated backing plate
- Noise insulating shims
- Hi-temp lubricant included
- Direct fit with the stock caliper, rear position
Pad compounds and heavy loads
Brake pad compounds trade off bite, heat tolerance, dust and noise. A pad built for heavier loads generally runs hotter, so the friction material and backing plate need to handle sustained braking on grades as well as stop-and-go driving. Matching the compound to how the truck is actually used matters more than chasing the highest grip rating.
Pads wear best when bedded in properly and when the rotors are in good condition. Replace rotors that are below minimum thickness or show deep grooves, and clean the caliper slide pins so the pad sits square against the rotor. Shims and hardware should go back in their original positions.
- Bed in new pads with a series of moderate stops
- Inspect rotors for heat cracks or uneven wear
- Keep caliper slide pins clean and lubricated
Specifications
| Brand | Power Stop |
|---|---|
| Part number | Z36-702A |
| UPC | 792088981950 |
| Product line | Z36 Truck and Tow |
| Position | Rear |
| Caliper | Stock |
| Fit | Direct fit |
| Type | Upgrade |
| Friction material | Carbon and ceramic formula |
| Finish | Thermal scorched |
| Pad design | Chamfered and slotted like OE |
| Backing plate | Powdercoated |
| Shims | Noise insulating |
| Lubricant | Hi-temp lubricant included |
| Coefficient of friction | 17 percent higher than OE pads (Power Stop) |
Vehicle fitment
The Z36-702A rear pads fit the 2001–2008 Dodge Ram 2500 and Ram 3500, from Base through Laramie, SLT, ST, SXT and Power Wagon.
Ram 2500 and 3500 model years after 2008 and front brake positions are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Fit this pad as a complete rear-axle job, never on a single wheel alone.
What’s included
- Z36 Truck and Tow rear brake pads, part Z36-702A
- Noise insulating shims
- Hi-temp lubricant
Not included: brake rotors and calipers.
