Overview
The Power Stop K5337-36 is a rear Heavy Duty Truck and Tow brake kit for the 2001–2010 Chevrolet Silverado 3500 and GMC Sierra 3500, including the Classic and HD versions.
The kit swaps in slotted and cross-drilled rotors and Z36 metallic pads on the rear axle of one-ton pickups. Power Stop leaves calipers and brake lines out, so the trucks’ own calipers carry over. Kits of this kind suit trucks that spend time under load, since the Z36 pad is the Truck and Tow option in Power Stop’s range. Power Stop says its kits bite harder than other leading brands while staying quiet and low in dust.
Key features
- Heavy-duty brake kit for trucks that tow
- Cross-drilled and slotted rotors paired with Z36 metallic pads
- Designed for braking when wet, hot, on hills, or hauling near maximum weight.
- Direct-fit pad and rotor set
- Calipers are not part of this kit
Towing and brake load
Heavy-duty trucks put sustained heat into the rear brakes when they carry a load down long grades. Under those conditions, pads can fade if the friction material and rotor cannot shed heat quickly. Cross-drilled and slotted rotors help move gas and water away from the pad face, but they do not replace good driving habits such as downshifting on descents.
Metallic pads tolerate heat well and grip reliably when the truck is loaded, though they tend to produce more dust and some noise when cold. Check the rear brake fluid and hoses at each service, and watch for a soft pedal after a long downhill run. A trailer brake controller should also be tested after new pads are installed.
- Downshift before long descents
- Test the trailer brake controller after the job
- Inspect rear hoses for cracks
- Expect some dust from metallic pads
Specifications
| Brand | Power Stop |
|---|---|
| Part number | K5337-36 |
| UPC | 70000683062 |
| Brake position | Rear |
| Rotor type | Slotted and cross-drilled |
| Brake pads | Z36 Truck and Tow high-friction metallic |
| Rotor coating | Coated |
| Calipers | Not included |
| Brake lines | Not included |
| Fit type | Direct fit |
Vehicle fitment
The kit fits the 2001–2006 Chevrolet Silverado 3500, the 2007 Silverado 3500 Classic, the 2007–2010 Silverado 3500 HD, and the GMC equivalents: the 2001–2006 Sierra 3500, 2007 Sierra 3500 Classic and 2007–2010 Sierra 3500 HD.
The list is for 3500 models only; it does not include the Silverado or Sierra 1500 or 2500. Rear axle only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rotors and pads in this kit take the place of the originals on the axle listed, and the calipers on the truck are retained. Brake lines are not supplied. Work on both sides of the axle together, since mixing old and new parts can pull the truck to one side.
What’s included
Rotors (slotted and cross-drilled) and Z36 Truck and Tow pads.
Not included: calipers and brake lines.









