Overview
The Power Stop Evolution JBR1370XPR (part number PSTJBR1370XPR) is a pair of rear drilled and slotted brake rotors for the 2006–2018 Toyota RAV4.
The solid cast iron rotors have 5 lugs. The drilled holes aid cooling under hard use, the rounded slots clear gas and debris, and the rotors are machined, mill-balanced and plated with silver zinc dichromate.
Run-out describes how much a rotor wobbles as it turns, and disc thickness variation (DTV) describes how much its thickness differs around the face. Lower figures for both generally point to a smoother pedal.
Power Stop gives the limits for this rotor as 0.0032 in (0.08 mm) of run-out and 0.0005 in (0.0125 mm) of DTV.
One part number fits every RAV4 from 2006 to 2018, so owners of older and newer examples within that span can use the same rear rotor. The rotor is a solid disc rather than a vented one, which suits its rear-axle role.
Key features
- Precision drilled holes allow rotor cooling
- Rounded slots wipe away gas and debris
- Silver zinc dichromate plating helps prevent rust and corrosion
- Mill-balanced; maximum run-out 0.0032 in (0.08 mm)
- Maximum DTV tolerance 0.0005 in (0.0125 mm)
- Solid cast iron rear rotors, 5 lugs
Rotor wear and pad pairing
Rear rotors wear more slowly than front ones on most vehicles, but they still develop scoring, thickness loss and heat cracks over time. Check the friction face for deep grooves and a ridge at the outer edge. Measure thickness against the minimum stamped on the rotor and replace any rotor below that figure or showing cracks, since thin rotors overheat quickly.
Pads and rotors wear as a pair. New rotors on worn pads, or old rotors under new pads, can cause vibration and uneven contact. Bed in new pads with a series of moderate stops after installation.
- Clean rust from the hub face before mounting
- Tighten lug nuts in a star pattern
- Check brake fluid level after pad replacement
- Listen for squeal from wear indicators
Specifications
| Brand | Power Stop |
|---|---|
| Part number | PSTJBR1370XPR |
| Product type | Rear brake rotors, drilled and slotted |
| Disc material | Cast iron |
| Disc design | Solid |
| Position | Rear |
| Number of lugs | 5 |
| Coating | Coated (silver zinc dichromate) |
| Maximum run-out | 0.0032 in (0.08 mm) |
| Maximum DTV tolerance | 0.0005 in (0.0125 mm) |
| Quantity | 2-wheel set |
| Fit | Direct fit |
Vehicle fitment
It fits the 2006–2018 Toyota RAV4, including Base, LE, XLE, Limited, SE, Sport, Platinum, Adventure, Hybrid Limited, Hybrid SE, Hybrid XLE and EV trims. A single part number covers every year from 2006 to 2018.
The 2019 and later RAV4 is a newer generation and is not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replace both rear rotors together and fit new rear pads.
What’s included
A set of two solid rear rotors.
Not included: Brake pads and mounting hardware.









