Overview
The Power Stop AR8646XPR is a rear slotted and cross drilled brake rotor that fits 2001-2010 Chevrolet Silverado 3500 and GMC Sierra 3500 models, including the Classic and HD versions.
Power Stop says these specialty rotors combine two technologies: they are slotted to degas the brake pads and cross drilled to aid cooling. The rotor is machined using Tru-Cast technology, is mill balanced, and is silver zinc plated to help shield and resist rust during normal operation.
Key features
- Slotted and cross drilled design
- Rear position
- Cross drilled holes help keep the rotor up to 180°F cooler.
- Rounded slots sweep away water, gas and dust to keep a clear contact patch
- Rotor run out within 0.0015 and DTV tolerance within 0.005
- Mill balanced and precision machined with Tru-Cast technology
- Silver zinc plated coating to resist rust
- G3000 grade cast
Choosing 3500 brake rotors
Rear rotors on heavy-duty pickups carry more load than many owners expect, especially when towing or hauling a full bed. A slotted and cross drilled face helps the pads shed gas and dust, but the open grooves and holes also give wear and heat cracks more places to start, so periodic inspection matters. Rotors and pads wear as a pair, and a new rotor set against glazed, uneven pads may not bed in evenly.
When a rear rotor is replaced, service both sides of the same axle so braking stays balanced. While the wheel is off, check the caliper slide pins and the parking brake hardware, because a sticking caliper can wear a new rotor unevenly. Clean the hub face so the rotor sits flat before the lug nuts are tightened.
- Measure rotor thickness against the minimum stamped on the casting
- Inspect caliper slide pins for corrosion
- Clean the hub face before mounting
- Bed in new pads with a series of gentle stops
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8646XPR |
| UPC | 792088917539 |
| Product type | Brake rotor |
| Type | Slotted and cross drilled |
| Position | Rear |
| Coating | Silver zinc plated (rotors coated) |
| Material | G3000 grade cast |
| Rotor run out | Within 0.0015 |
| DTV tolerance | Within 0.005 |
| Balancing | Mill balanced |
| Fitment type | Direct fit |
Vehicle fitment
Listed fitment: 2001-2006 Chevrolet Silverado 3500, 2007 Chevrolet Silverado 3500 Classic, 2007-2010 Chevrolet Silverado 3500 HD, 2001-2006 GMC Sierra 3500, 2007 GMC Sierra 3500 Classic and 2007-2010 GMC Sierra 3500 HD, in the trims shown in the Fitment tab.
This is a rear rotor for the 3500 models listed. The list does not cover the Silverado or Sierra 1500 and 2500 models, or 3500 HD models after 2010. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Brake components are safety-critical, so professional installation is recommended. Torque every fastener to its specified value, replace related hardware as needed, and inspect the surrounding brake parts at the same time. Keep rotors, pads and friction surfaces free of grease and oil. After installation, check pedal feel at low speed in a safe area and re-check fasteners after the first miles of driving.
What’s included
One rear slotted and cross drilled brake rotor, part number AR8646XPR.
Not included: Brake pads, calipers, hardware and the matching rotor for the other side.









