Overview
The Power Stop AR8636XPR is a rear slotted and cross-drilled brake rotor for the 1997–2005 Chevrolet Blazer, the 1998–2004 Chevrolet S10 and GMC Sonoma, the 1997–2001 GMC Jimmy and related models. The AR8636XPR is made for the rear axle, uses cross-drilled holes together with slots, and arrives coated.
Power Stop machines each rotor using Tru-Cast technology and mill balances it, holding run out within 0.0015 and a DTV tolerance specification within 0.005.
The AR8636XPR is a coated, direct-fit rotor, and Power Stop highlights its mill balancing, the zinc plated finish and the slots that keep the pad contact patch clean.
Key features
- Rounded slots clear water, gas and dust
- Cross-drilled holes for cooling
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Rear brakes on compact trucks
Rear rotors on compact pickups and SUVs usually carry less braking load than the fronts, but they still take a meaningful share of stopping force. The parking brake is often applied at the rear, so hubs and rotor faces can rust when a truck sits for long periods. Cleaning and inspecting these surfaces during a rotor change helps the new part seat properly.
Rear pads can wear at different rates from the fronts, so check their thickness whenever the rotors are serviced. Drilled and slotted faces show more pad dust than smooth faces, which is normal, and debris trapped in the slots should be cleared. Look for cracks that start at holes or slots, since they signal the rotor is nearing the end of its service life.
- Check parking brake shoes or cable if equipped
- Compare pad thickness on both sides
- Lubricate slide pins with the correct grease
- Inspect brake lines near the axle
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8636XPR |
| UPC | 792088553577 |
| Type | Slotted and cross drilled |
| Position | Rear |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | The holes keep rotors up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
It fits 1997–2005 Chevrolet Blazer (Base, LS, LT, Trailblazer, ZR2); 1998–2004 Chevrolet S10 (Base, LS, ZR2, ZR5); 1997–2001 GMC Jimmy (Diamond Edition, Envoy, SL, SLE, SLS, SLT); 1998–2004 GMC Sonoma (SL, SLE, SLS); 1998–2000 Isuzu Hombre (S, XS); and 1997–2001 Oldsmobile Bravada (Base). It is a rear rotor.
It covers the rear axle only, so check your year, model and trim against the vehicles above before buying.
Installation notes
Install the AR8636XPR on the rear axle only, and plan on fresh brake pads, since a drilled and slotted face works with pads that are in good condition.









