Overview
The N-Fab RBS C14RBS is a black replacement rear bumper with a 3/16 inch polished aluminum skid plate. N-Fab designs it as an all bolt-on bumper that it says will not flex, and makes it in the U.S.A.
N-Fab builds its tubular parts from .084 wall steel in a fully welded one-piece construction, zinc coats each part for corrosion protection and finishes it in a thick layer of high-gloss powder coat. No vehicle list or model years are given for this part number.
The kit pairs a replacement bumper body with a 3/16 inch polished aluminum skid plate. It has no receiver hitch, tire carrier or D-ring mounts of its own. Use the part number to confirm fit before ordering.
Key features
- Replacement rear bumper with skid plate
- 3/16 inch polished aluminum skid plate included
- All bolt-on design that N-Fab says will not flex
- Powder-coat finish over zinc coating
- Made in the U.S.A.
Rear bumper mounting checks
A rear bumper takes the rear end’s exposure to rocks, logs and low-speed contact, and it has to sit square with the tailgate, taillights and any rear sensors. Before installing, compare the new bumper’s mounting points with the old one, and make sure the license plate area and spare tire clearance still work. Small misalignment can cause rattles or stress on the mounts.
Because this bumper has no receiver hitch or tire carrier, any towing or spare tire setup needs its own parts and mounting points. Use the bolts with the proper torque and recheck them after the first few trips. Inspect the welds and skid plate mounts regularly, especially after trail use.
- Test tailgate opening and closing after installation
- Check backup sensor alignment if equipped
- Route wiring away from the skid plate edge
Specifications
| Brand | N-Fab |
|---|---|
| Part number | C14RBS |
| UPC | 843206103201 |
| Product type | Replacement rear bumper |
| Skid plate | 3/16 inch polished aluminum |
| Finish | Black powder coat |
| Receiver hitch | No |
| Tire carrier | No |
| D-ring mounts | Not included |
| Fit type | Direct fit |
Vehicle fitment
Find the year, model and trim that match this part before ordering, then compare the bumper’s mounting points with your truck.
Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
One replacement rear bumper with a 3/16 inch polished aluminum skid plate.









