Overview
The Icon Suspension 78600 is a tubular upper control arm kit for 2007+ Chevrolet and GMC 2WD and 4WD half ton trucks and SUVs. It uses 1 inch PTFE lined uniballs with 17-4 stainless taper pin adapters.
Icon designed the kit because weak OEM ball joints can limit suspension travel, especially with 2.5 inch VS Series performance coil-over shocks. The arms are CNC bent from 1026 DOM seamless tubing and use a 4130 CNC machined uniball cup, which Icon says allows smooth, clean wheel travel without factory ball joint bind.
Key features
- Available for 2WD and 4WD models
- CNC bent 1026 DOM seamless tubing
- 4130 CNC machined uniball cup
- 1 inch PTFE lined uniballs
- 17-4 stainless taper pin adapters
- Front position
Ball joints and wheel travel
A factory ball joint limits how far the upper arm can move before it binds, which matters on trucks with lifted or performance coil-over shocks. Replacing that joint with a uniball and taper pin adapter changes how the upper arm pivots, so the wheel can travel more freely. Check the adapters for play or cracking before each season of use.
Upper arm geometry changes with a uniball setup, so camber and caster should be checked after installation. Protect the uniball seal from grit and road debris, and inspect the cup for wear at regular service. Replace worn taper pin adapters as a set rather than one at a time, which keeps the arm loaded evenly.
- Inspect uniball seals for tears
- Check taper pin adapters for play
- Recheck camber and caster after installation
Specifications
| Brand | Icon Suspension |
|---|---|
| Part number | 78600 |
| UPC | 70000615945 |
| Position | Front |
| Drive | 2WD and 4WD |
| Tubing | 1026 DOM seamless |
| Uniball cup | 4130 CNC machined |
| Uniball | 1 inch PTFE lined |
| Taper pin adapters | 17-4 stainless |
Vehicle fitment
The kit fits 2007+ Chevrolet and GMC 2WD and 4WD half ton trucks and SUVs. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the kit relies on uniballs and taper pin adapters rather than the factory ball joint, check the included adapters against your arm before assembly. Alignment should be checked afterward, since upper arm geometry changes.
What’s included
The kit includes the tubular upper arm system, 4130 uniball cups, 1 inch uniballs and 17-4 taper pin adapters.
Not included: 2.5 inch VS Series coil-over shocks are a separate product and are not part of this kit.