Overview
The Icon Suspension 22020 is a Centerline steering stabilizer for the 2007–2018 Jeep Wrangler JK, covering 2-door and 4-door models. It is built for vehicles with a 3 to 6 inch lift and will not work on a stock vehicle. A minimum 1 inch bump stop spacer is required for adequate clearance.
The through shaft design is meant to remove the push and pull that traditional stabilizers produce, giving steering that feels symmetrical through the input range. The adjustable Drive Zone offers 9 clicks of damping adjustment across 110 degrees of steering wheel input left and right of center.
Key features
- Through shaft design that avoids the push and pull of traditional stabilizers
- Adjustable Drive Zone with 9 clicks of damping adjustment
- High clearance design with a rotatable reservoir for proper fitment across lift heights
- 100% bolt-on installation
- Mounts to the OE 1-3/8 inch tie rod
- ICON 2.0 aluminum series shock with a fully serviceable body
- FK rod end bearings for precise function
Choosing damping and lift height
A steering stabilizer’s job changes with lift height and tire size. Higher lifts change the angles the stabilizer works at, and larger tires add weight and inertia to the steering. A damper set for the right lift and tire combination keeps the front end more controlled over washboard roads and at highway speed.
Reservoir position is one of the first things to check during installation, since it affects clearance on lifted trucks. Plan for the bump stop spacer before fitting. Once installed, check the rod ends and tie rod mount for play, and cycle the steering through its full range to confirm there is no binding.
- Match the stabilizer to the installed lift
- Check reservoir clearance
- Plan for the bump stop spacer before fitting
- Recheck rod ends after the first drives
Specifications
| Brand | Icon Suspension |
|---|---|
| Part number | 22020 |
| UPC | 700008407071 |
| Lift range | 3 to 6 inches |
| Damping adjustment | 9 clicks (Drive Zone) |
| Steering input range | 110 degrees left and right of center |
| Shock series | ICON 2.0 Aluminum Series, fully serviceable |
| Shock body | 6063 clear anodized aluminum |
| Shaft | 5/8 inch chrome plated hardened steel |
| Shock oil | 5WT |
| Rod ends | FK rod end bearings |
| Tie rod mount | OE 1-3/8 inch |
| Fit type | Direct fit |
Vehicle fitment
It is built for the 2007–2018 Jeep Wrangler (JK), including the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, and the Unlimited versions of those trims. Confirm fit for your vehicle’s year, model and trim before ordering.
Wrangler JL models from 2018 on, the Gladiator, and earlier Wrangler generations such as TJ and LJ are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The stabilizer is 100% bolt-on, but the reservoir position depends on lift height. Kits 4.5 inches and taller allow the reservoir to be rotated straight up above the shock body. Three inch kits require the reservoir to be rotated down behind the shock body. Plan for at least a 1 inch bump stop spacer.
What’s included
The stabilizer comes with its shock, rod end bearings and tie rod mount.
Not included: The minimum 1 inch bump stop spacer is required for adequate clearance and is not in the box. Obtain it before installation.









