Overview
The G2 Axle and Gear 2-2032-488R is a 4.88 ratio front reverse ring and pinion for the Dana 30 front axle. It fits the Jeep XJ Cherokee from 1984 to 1999 and the Jeep YJ Wrangler from 1987 to 1995, in a Dana 30 reverse layout made for carriers of 3.73 and up.
G2 describes these gears as made for oversized tires and high performance engines, using computer heat treated 8620 steel with double shot peened and double lapped surfaces. The gears are manufactured to O.E. specifications.
Key features
- Dana 30 reverse front ring and pinion
- 4.88 ratio for 3.73 and up carriers
- Fits XJ Cherokee and YJ Wrangler front axles
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Reverse Dana 30 front axles
Dana 30 front axles on older Jeeps see years of trail use, and the front end often shows wear in the hubs, axle shafts and joints before the gears fail. A front reverse set is one part of a larger front axle job, so the surrounding parts deserve attention whenever the carrier is opened. Older housings can also show wear at the bearing bores, which affects how the new gears seat.
A 4.88 ratio pulls harder at low speed than a numerically lower set, which suits trail driving with larger tires. Break-in matters for this kind of gear, so run it gently at first and recheck tooth contact after the initial drives. Keep the axle fluid clean and check it for metal after the first few runs.
- Inspect hub and axle shaft parts when the axle is opened
- Check the bearing bores for wear before fitting
- Recheck tooth contact after the initial drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2032-488R |
| UPC | 631410093933 |
| Gear ratio | 4.88 |
| Axle location | Front |
| Axle type | Dana 30 reverse |
| Popular axle manufacturer | Dana |
| Carrier requirement | 3.73 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is made for the front Dana 30 reverse axle in the Jeep XJ Cherokee from 1984 to 1999 and the Jeep YJ Wrangler from 1987 to 1995.
This set covers only the Jeep XJ Cherokee and YJ Wrangler years above. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Front reverse gears need pinion depth, backlash and bearing preload set by a driveline shop. Run the 4.88 gears through a break-in period once the front axle is assembled.
What’s included
A matched front reverse ring and pinion for the Dana 30 axle.
















