Overview
The G2 Axle and Gear 2-2049-373 is a 3.73 ratio ring and pinion for the Dana 35 rear axle. It is made for carriers rated 3.54 and up, so the carrier should be rated at or above that ratio.
This performance gear set is made for oversized tires and high performance engines. It uses computer heat treated 8620 steel with double shot peened and double lapped surfaces, and it is manufactured to O.E. specifications.
Key features
- 3.73 ratio rear ring and pinion
- Dana 35 rear axle
- For use with 3.54 and up carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Matching carrier and ratio
Gear ratio describes how many turns of the pinion it takes to turn the ring gear once, so a numerically higher ratio gives stronger acceleration at the cost of engine speed on the highway. A gear set should be matched to the carrier rating the axle was built with, since mismatched carriers can affect mesh and bearing life.
A Dana 35 rear is often used in trucks and SUVs that tow, climb trails, or drive on mixed roads, and the gear ratio is usually chosen with the tire size in mind. Taller tires lower the effective ratio, so a shopper running larger tires should think about how the final drive will feel before buying.
- Check the carrier tag for its rated ratio
- Replace the pinion seal when the gears are changed
- Use a gear oil that suits the differential type
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2049-373 |
| UPC | 631410094510 |
| Gear ratio | 3.73 |
| Axle location | Rear |
| Axle type | Dana 35 |
| Popular axle manufacturer | Dana |
| Carrier requirement | 3.54 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is built for the Dana 35 at a 3.73 ratio. Confirm the axle and carrier before ordering.
Parts for the Dana 30, Dana 44 or other Dana sizes are a different fit. Match your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the Dana 35 gears should be set by a driveline shop, followed by a break-in period on the 3.73 ratio.
What’s included
A matched ring and pinion for the Dana 35 rear axle.















