Overview
The 2-2057-488 is a front axle ring and pinion gear set with a 4.88 gear ratio for the Toyota FJ Cruiser IFS. It requires a 3.90 and up carrier.
G2 says these gears suit oversized tires and high-output engines. They are computer heat treated from 8620 steel, double shot peened and double lapped, and manufactured to O.E. specifications.
Key features
- 4.88 gear ratio
- Requires a 3.90 and up carrier
- Computer heat treated 8620 steel
- Double shot peened and double lapped
- Manufactured to O.E. specifications
- 10 year warranty from G2
Front carrier and ratio matching
The carrier ratio decides whether a 4.88 gear set will work, so check the carrier before anything else. A front carrier that is too small for the set can be damaged under load, and a mismatch will show up as noise and poor tooth contact. Confirm the carrier has the right ratio, the correct pinion bearing setup and the proper shim stack before ordering.
Front gears on an IFS vehicle also see steering and drive loads, and they are often used with larger tires. Once installed, check for a quiet pattern and clean gear oil after the first few drives. Replacing the pinion and carrier bearings with the gears keeps the preload consistent from the start.
- Verify the carrier ratio before buying
- Replace pinion and carrier bearings with the gears
- Check the front gear oil after early drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2057-488 |
| UPC | 631410094701 |
| Axle location | Front |
| Axle type | Toyota FJ Cruiser IFS (independent front suspension) |
| Axle manufacturer | Toyota |
| Gear ratio | 4.88 |
| Carrier requirement | 3.90 and up |
| Material | Computer heat treated 8620 steel |
| Finishing | Double shot peened, double lapped |
| Warranty | 10 years |
Vehicle fitment
The axle is the Toyota FJ Cruiser IFS, but no model years or chassis code are tied to this set. Check the year range for your front axle and carrier ratio before ordering.
Installation notes
A gear shop should set pinion depth and backlash, and the set needs a break-in period afterward. Confirm your carrier’s ratio before ordering, since this set requires a 3.90 and up carrier.
What’s included
The ring and pinion set only. Bearings, shims, carrier parts and installation hardware are not part of this set.













