Overview
The G2 Axle and Gear 2-2056-529 is a 5.29 ratio ring and pinion for the Toyota Tacoma 8.4 Inch axle. The pinion turns 5.29 times for each full turn of the ring gear, a numerically high ratio that favors acceleration and low-speed pulling over highway rpm.
This set is made for the Toyota Tacoma 8.4 Inch axle in front and rear positions. It is designed for oversized tires and high-performance engines. Verify the axle size and position on your vehicle before ordering.
Key features
- 5.29 gear ratio for the Toyota Tacoma 8.4 Inch axle
- Fitted in front or rear positions
- Ring gear and pinion sold as one matched set
- Built for oversized tires and high-performance engines.
- Manufactured with current methods and materials.
Tooth contact and setup
A 5.29 set is a steep ratio that favors acceleration and low-speed pulling. Its tooth contact pattern must be correct for the gears to run quietly and last. Painting the teeth with marking compound and rolling the pinion lets the installer see whether the pattern sits near the center of the tooth face.
Once the gears are running, watch for noise that changes with speed, load or coast. A whine on drive or a clunk on tip-in can point to incorrect backlash or a loose ring gear. Stop and check the setup if either appears, rather than continuing to drive on a damaged set.
- Tooth contact pattern with marking compound
- Backlash measured at the ring gear
- Ring gear bolts torqued to specification
- Fresh gear oil after installation
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2056-529 |
| UPC | 631410094688 |
| Axle type | Toyota Tacoma, 8.4 Inch (per title) |
| Axle location | Front or rear |
| Gear ratio | 5.29 |
| Axle manufacturer | Toyota |
Vehicle fitment
The set is intended for the Toyota Tacoma 8.4 Inch axle. Match the ring gear size and carrier on your truck before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 5.29 set needs precise tooth contact and carrier preload, so a gear shop with setup tools is the usual installer. A break-in period is recommended before heavy use.
What’s included
One 5.29 ring and pinion set for the Toyota Tacoma 8.4 Inch axle, part number 2-2056-529.
Not included: Carrier bearings, shims and installation hardware are not part of the 5.29 Tacoma set.















