Overview
The G2 Axle and Gear 1-2097-410 is a 4.10 ratio O.E.M. series ring and pinion for the rear axle. It is made for the Chrysler 10.25 inch AAM axle type. The Dodge 10.5 inch 14 bolt housing name does not match that axle type, so confirm the housing before ordering.
G2 says its O.E.M. series gears are designed to run cooler and quieter than aftermarket gears, and that the company contracted with original equipment manufacturers to make them.
Key features
- O.E.M. series 4.10 ring and pinion
- Rear axle location
- Chrysler 10.25 inch AAM axle type listed
- Manufactured under contract with original equipment manufacturers.
- Runs cooler and quieter than aftermarket gears.
Matching the housing
A ring and pinion sets the final drive ratio of the axle, so it changes how engine torque reaches the wheels. A 4.10 set gives more wheel torque at low speed, which helps with climbing and towing, while the engine turns faster at highway speed. The gears only work correctly inside the carrier and housing they were made for, so the axle type matters as much as the ratio.
Most gear swaps replace the pinion bearings, carrier bearings and crush sleeve along with the set. Old bearings can change preload and cause noise, so new ones are the safer choice. Inspect the carrier bores and the housing for cracks before assembly, and keep the matched gears together as one pair.
- Check the housing and axle type before buying gears
- Replace pinion and carrier bearings with the set
- Inspect carrier bores for wear or cracks
- Expect some noise until the gears settle in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2097-410 |
| UPC | 631410093155 |
| Gear ratio | 4.10 |
| Axle location | Rear |
| Axle type | Chrysler 10.25 inch AAM |
| Popular axle manufacturer | Chrysler |
| Series | O.E.M. |
Vehicle fitment
No vehicle model or year is named for this 4.10 set. It is listed by axle type as the Chrysler 10.25 inch AAM, so match the housing and the axle name before ordering.
It is made for the Chrysler 10.25 inch AAM axle type. Match your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the 4.10 gears should be set by a driveline shop, followed by a break-in period.
What’s included
A matched O.E.M. series ring and pinion for the rear axle.
















