Overview
The G2 Axle and Gear 1-2060-391 is a GM 218 mm ring and pinion set with a 3.91 ratio from the G2 OE series. A ring and pinion set is the gear pair inside a differential that transfers driveshaft rotation to the axle shafts, and a ratio such as 3.91 sets how many pinion turns go with one ring gear turn.
G2 designs its OEM Series gears for quiet operation, strength and ease of installation. They are made in the same factories that supply original equipment makers, and they are forged from high quality gear steel.
The 1-2060-391 is part of the G2 OE series. The 218 mm size refers to the ring gear, which identifies the GM axle design, and 3.91 is the gear ratio. This OE set is not made from 8620 gear steel; 8620 steel is used in the separate Performance Series.
Key features
- GM 218 mm ring and pinion set
- 3.91 gear ratio
- OE Ring and Pinion Set from the G2 OEM Series
- Forged from high quality gear steel.
- Manufactured in the same factories that supply original equipment makers.
Setting up a ring and pinion
A new ring and pinion has to be set up before it runs smoothly. Pinion depth controls where the teeth meet, backlash sets the small clearance between the gears, and the tooth contact pattern shows whether they are seated correctly. Each of these should be checked with the gears installed in the carrier, not assumed from the part alone.
Carrier bearings and shims are commonly replaced with the new set, since worn bearings can change the setup. Break-in after installation is also important, with light loads at first and gradually increasing use, so the new teeth can bed in evenly and run quietly over time.
- Check pinion depth and backlash before final assembly
- Verify tooth contact pattern with marking compound
- Replace carrier bearings when the gears are replaced
- Drive gently during the break-in period
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2060-391 |
| UPC | 631410118773 |
| Axle | GM 218 mm |
| Gear ratio | 3.91 |
| Series | OE (OEM Series) |
Not stated by the manufacturer: the axle position, tooth counts, installation hardware and which GM vehicles use the 218 mm axle.
Vehicle fitment
No manufacturer fitment list is available for part 1-2060-391, and the manufacturer text names no vehicle. The set is specific to the GM 218 mm axle size, so match it to the axle in your vehicle.
Not stated: any vehicle year, make or model, and other axle sizes are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
G2 describes OEM Series gears as easy to install, but a ring and pinion still needs correct pinion depth and backlash and a check of the tooth contact pattern, followed by a break-in period.









