Overview
The G2 Axle and Gear 95-2041-001 is a rear replacement axle shaft for the Toyota 8 inch axle, described by G2 for the 1979–1985 Toyota 4×4 truck and 4Runner. It has 30 splines and 12mm press-fit wheel studs.
The shaft fits either the driver or passenger side. It is forged from high grade alloy steel and heat treated to exceed OEM specifications.
The 95-2041-001 has 30 splines and uses 12mm press-fit studs, and G2 Axle and Gear catalogs it for the Toyota 8 inch rear axle on either side. The company says its shafts are forged from high grade alloy steel and heat treated beyond OEM specifications. Since G2’s wording and its vehicle list disagree, confirm the application before fitting the shaft.
Key features
- 30 splines
- 12mm press-fit wheel studs
- Either driver or passenger side
- Toyota 8 inch rear axle
- Forged alloy steel, heat treated beyond OEM specifications.
- Wheel studs not included
Before you install
Axle shafts on a Toyota 8 inch rear carry drive torque from the differential to the wheel, so the splines and hub bore must match before the shaft goes in. Check that the spline count on the new shaft matches the differential side gear, and inspect the spline ends for rounded teeth. A shaft that does not seat fully can slip under load and wear the hub.
Because the studs are not included with this shaft, plan on pressing new 12mm studs into the hub. Clean the stud bores and make sure the flange sits flat against the hub so the shaft seats squarely. After the first few trail runs, re-check the axle nuts and wheel lug torque, and listen for clicks on tight turns.
- Inspect the old shaft for twisted splines or cracks
- Replace the axle seal when the shaft comes out
- Check the carrier bearing for play
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2041-001 |
| UPC | 631410106435 |
| Product type | Replacement axle shaft |
| Axle type | Toyota 8 Inch |
| Axle location | Rear |
| Shaft position | Driver Or Passenger |
| Spline count | 30 |
| Press-fit wheel stud size | 12mm |
| Wheel studs | Not included |
| Stated application | 1979-1985 Toyota 4×4 Truck/4 Runner |
Vehicle fitment
G2’s vehicle list for the 95-2041-001 shows the 1979–1980 International Scout II.
G2’s text says Toyota 4×4 Truck/4Runner for 1979–1985, which does not match that list. Confirm the application with G2 before use. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Supply 12mm studs, as none are included.
- Confirm the axle is a Toyota 8 inch unit.
What’s included
One rear axle shaft that fits either side (95-2041-001).
Not included: 12mm wheel studs for the 95-2041-001.






