Overview
The G2 Axle and Gear 95-2013-012 is a rear shaft for Ford 8.8 inch axles, sold for either the driver or passenger position, with 28 splines. G2 designs its shaft line for high torque loads and longer service life.
Its forged alloy steel is heat treated beyond OEM specifications. Vehicle years and models are unknown for this shaft.
Key features
- Driver or passenger position on Ford 8.8 inch axles
- 28 spline count
- Forged alloy steel construction
- Heat treated to exceed OEM specifications
Life under load
A rear axle shaft on a Ford 8.8 inch axle carries the full torque of the engine to the wheel, and the load is hardest on launches and when the tires grip hard. Over time the spline ends and the retaining clip are the points that tend to show wear. Watching for changes in these areas helps catch a problem before the shaft fails on the trail or on the road.
Routine checks are simple. Keep the differential fluid fresh, look at the axle tube seals for leaks, and inspect the shaft ends for twisting or polished splines after rough runs. If a shaft is damaged on one side, check the other side at the same time, since both shafts share the same load paths and wear rates.
- Check spline ends for twisting
- Inspect axle tube seals for leaks
- Keep differential fluid fresh
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2013-012 |
| UPC | 631410105926 |
| Axle type | Ford 8.8 Inches |
| Axle location | Rear |
| Shaft location | Driver or passenger |
| Axle spline | 28 splines |
| Popular axle manufacturer | Ford |
Vehicle fitment
Match your axle to the Ford 8.8 inch type and 28 spline count before buying, and check the side needed.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Only the rear axle shaft is included. Check hardware and seals against your installation before starting.









