Overview
The G2 Axle and Gear 97-2032-006 is a Dana 30 chromoly inner axle shaft for the driver side, with 27 splines and a 28.69 inch overall length. It is for 1982–1986 Jeep CJ models.
G2 positions its shafts for owners with oversized tires and high torque, and they are designed for extended service life. The steel is forged high-grade alloy, heat treated beyond OEM specifications. The 97-2032-006 has 27 splines, and the differential or carrier it works with must use the same spline count. An inner axle shaft is the long section that runs from the differential through the axle tube to the U-joint, so the two sides of a front axle differ in length. At 28.69 inches, the 97-2032-006 is a long shaft, which suits a driver side inner position that spans most of the axle width on a Dana 30 front end.
Key features
- Chromoly inner axle shaft for the Dana 30 front axle
- Driver side, 27 spline, 28.69 inch overall length
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- It fits 82-86 Jeep CJ models.
Choosing a replacement shaft
An inner shaft must match the differential in spline count, side and overall length, so measure the shaft you are replacing before buying. The left and right inner shafts on a front axle differ in length, and a shaft on the wrong side can bind or fail to seat. Confirm the U-joint size and clip style on the old shaft as well.
Signs that an inner shaft is wearing out include clicking on tight turns, vibration under acceleration, and grease escaping from the axle seal. Inspect the splines for rounding or twisting, and check the U-joint for play. Because the shaft runs through the axle tube, a leaking seal may already have damaged the shaft, so inspect those parts while the shaft is out.
- Measure overall length from one end of the shaft to the other
- Compare spline count with the differential side gears
- Replace a bent or twisted shaft rather than straightening it
- Pack the new U-joint with fresh grease at assembly
Specifications
The 97-2032-006 is a chromoly inner axle shaft for the Dana 30 front, standard axle, with 27 splines and an overall length of 28.69 inches. Every figure in the table below is the manufacturer value for the 97-2032-006.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2032-006 |
| UPC | 631410097085 |
| Part type | Chromoly inner axle shaft |
| Axle | Dana 30 front, standard |
| Axle shaft location | Driver side inner |
| Spline | 27 spline |
| Overall length | 28.69 inches |
| U-joint | Accepts 5-760X U-joint |
| Clip design | Machined to accept full circle clips |
| Application stated | 82-86 Jeep CJ |
Vehicle fitment
No vehicle year or model list is published for the 97-2032-006; check the manufacturer specifications for the exact application.
Application: 82-86 Jeep CJ.
Before ordering the 97-2032-006, compare its spline count, side and overall length with the shaft being replaced.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is the long driver side inner shaft used on the CJ Dana 30. It accepts a 5-760X U-joint and full circle clips.






