Overview
The G2 Toyota 8-inch 4.88 ratio ring and pinion, part number 2-2041-488, is a gear set for Toyota 8-inch axles. It has a 4.88 gear ratio and works with all ratio carriers.
The gears are engineered for oversized tires and high-performance engines. They are made from computer heat treated 8620 steel to original equipment specifications, double shot peened and double lapped. A 10-year warranty covers the set.
G2 positions the set for larger tires and high-performance engines, which is where a numerically higher ratio such as 4.88 is used. Setup should be done by a professional, and the gears need a break-in period before they are used hard.
Key features
- 4.88 gear ratio
- Computer heat treated 8620 steel
- Double shot peened for strength
- Double lapped
- Works with all ratio carriers
- 10-year warranty
Matching the gears to the job
Numerically higher ratios such as 4.88 change how an axle behaves. The driveshaft turns more times for each wheel revolution, which helps with larger tires and loaded towing, while highway engine speed rises. Choosing a ratio is a trade between low-end pull and highway calm, so match it to the tire size and driving you do most.
Because a ring and pinion set is only as good as its mesh, install the new gears with new pinion and carrier bearings, seals and fresh gear oil. Old bearings that ran with the earlier ratio can carry wear that upsets pinion depth and preload. Keep throttle and load moderate during the first drives so the contact pattern can settle.
- Check the carrier size before buying
- Replace bearings and seals with the gears
- Confirm backlash and contact pattern before closing the housing
- Re-check gear oil level after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2041-488 |
| UPC | 631410094312 |
| Gear ratio | 4.88 |
| Axle type | Toyota 8-inch |
| Material | 8620 steel |
| Heat treatment | Computer heat treated |
| Surface treatment | Double shot peened |
| Lapping | Double lapped |
| Carrier compatibility | All ratio carriers |
| Warranty | 10 years |
Vehicle fitment
It is a universal fit for the Toyota 8-inch axle type. Match it to your axle and carrier size before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Professional setup is recommended for ring and pinion gears, and the gears need a break-in period before they are used hard.
What’s included
One ring and pinion gear set with a 4.88 ratio.
















