Overview
The G2 Axle and Gear 2-2028-390 is a 3.90 ratio ring and pinion for the Chrysler 9.25 inch rear axle. It fits the rear location and works with all ratio carriers.
G2 describes these gear sets as designed for oversized tires and high performance engines. The 3.90 gears are made from computer heat treated 8620 steel with double shot peened and double lapped surfaces, to O.E. specifications.
Key features
- 3.90 ratio rear ring and pinion
- Chrysler 9.25 inch rear axle
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Gear ratio and daily use
Gear ratio decides how many times the driveshaft turns for each turn of the wheels. A 3.90 set is a moderate choice that keeps highway engine speed lower than a numerically higher gear would, while still giving the axle a useful amount of torque for normal loads. Drivers who run larger tires often compare the final ratio with the tire diameter before settling on a set.
Ring gear and pinion wear usually shows up as whine, hot axle housings or fine metal in the gear oil. When the axle is open for a new set, check the pinion bearings, carrier bearings and pinion seal, since they are often replaced in the same job. Fresh gears will not last long on worn bearings.
- Check the pinion seal for leaks
- Inspect carrier bearing preload after the first drives
- Keep a record of the set ratio for future service
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2028-390 |
| UPC | 631410093773 |
| Gear ratio | 3.90 |
| Axle location | Rear |
| Axle type | Chrysler 9.25 inch |
| Popular axle manufacturer | Chrysler |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is made for the Chrysler 9.25 inch axle at a 3.90 ratio. Confirm the housing size before ordering.
Only the Chrysler 9.25 inch is named for this 3.90 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A driveline shop should set pinion depth, backlash and bearing preload on the 3.90 Chrysler gears, followed by a break-in period.
What’s included
A matched ring and pinion for the Chrysler 9.25 inch rear axle.














