Overview
The G2 Axle and Gear 2-2080-463 is a 4.63 ratio ring and pinion for the rear Dana 80 axle. The pinion turns 4.63 times for each full turn of the ring gear, a numerically high ratio that multiplies torque at the wheels.
G2’s Performance Ring and Pinion range is made for oversized tires and high-performance engines. This 4.63 set is made for the rear Dana 80 axle, so measure the housing and carrier on your vehicle before buying.
Key features
- 4.63 gear ratio for the Dana 80 rear axle
- Rear axle location
- Ring gear and pinion sold as one set
- Designed for oversized tires and high-performance engines.
- Built with current materials and manufacturing methods.
Carrier fit and gear care
The Dana 80 is a heavy-duty rear axle, and a 4.63 ratio is often chosen for trucks that carry loads or run larger tires. The numerically high ratio gives stronger pulling from a stop and easier control on grades, at the cost of more engine rpm on the highway. Choosing the ratio is mostly a question of how the vehicle is driven day to day.
Carrier condition matters as much as the gears. Worn carrier bearings or a damaged pinion bearing can let the ring gear move, which shows up as noise and uneven wear. When the axle is opened, inspect the bearings, seals and the carrier cage, and replace parts that show damage before the new gears go in.
After installation, keep an eye on noise during light throttle and coast, and check the fluid for metal particles after the first few drives. Gear life depends on a correct setup, so a gear shop with the right tools is the usual choice for this axle size.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2080-463 |
| UPC | 631410094732 |
| Axle type | Dana 80 |
| Axle location | Rear |
| Gear ratio | 4.63 |
| Axle manufacturer | Dana |
Vehicle fitment
This 4.63 set is made for the rear Dana 80 axle. Confirm that housing and carrier on your vehicle before ordering, and confirm fit for your vehicle’s year, model and trim.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 4.63 set needs measured tooth contact and carrier preload, so a gear shop is the practical installer. Break in the gears before towing heavy loads.
What’s included
One 4.63 ring and pinion set for the rear Dana 80 axle, part number 2-2080-463.
Not included: Carrier bearings, shims and installation hardware.
















