Overview
The G2 2-2064-488 is a 4.88 ratio ring and pinion for the Toyota 10.5 inch 12 bolt rear axle. It fits the rear location and works with all ratio carriers, so the carrier does not restrict the choice.
G2 describes its gear sets as engineered for oversized tires and high performance engines. This 10.5 inch Toyota set is made from computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- 4.88 ratio rear ring and pinion
- Toyota 10.5 inch 12 bolt axle
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Living with a 12 bolt rear
The 12 bolt housing is a common rear axle in light trucks, and its ring gears are often swapped to change ratio for tire size or trail use. A 4.88 ratio shifts the gearing toward low-speed pull, which suits larger tires and slower technical terrain, though highway cruising runs the engine faster.
Keep the rest of the axle in mind during the job. Pinion bearings, carrier bearings and axle seals are good candidates for replacement while the carrier is out. Listen for a howl or clunk after the new gears are installed, since that often points to backlash or preload that needs another look.
- Replace axle seals while the carrier is open
- Check the cover gasket for a clean seal
- Note the old pinion depth before removal
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2064-488 |
| UPC | 631410127980 |
| Gear ratio | 4.88 |
| Axle location | Rear |
| Axle type | Toyota 10.5 inch 12 bolt |
| Popular axle manufacturer | Toyota |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
The set covers the Toyota 10.5 inch 12 bolt at a 4.88 ratio. Confirm the axle and year before ordering.
Only the Toyota 10.5 inch 12 bolt is named for this 4.88 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A driveline shop should set pinion depth, backlash and bearing preload on the 10.5 inch Toyota gears, followed by a break-in period.
What’s included
A matched ring and pinion for the Toyota 10.5 inch 12 bolt rear axle.














