Overview
The G2 Axle and Gear 2-2014-373 is a 3.73 ratio ring and pinion for the rear Ford 7.5 Inch axle. The pinion turns 3.73 times for each ring gear revolution, a middle-range ratio that balances acceleration against highway rpm.
The Performance Ring and Pinion range is designed for oversized tires and high-performance engines, and it is built with current materials and manufacturing. The set is matched to the Ford 7.5 Inch axle, so the housing decides fit before purchase.
Key features
- 3.73 gear ratio for the Ford 7.5 Inch rear axle
- Ring gear and pinion supplied as a matched set
- G2 rates the set for oversized tires and high-performance engines
- It is built with current materials and methods.
- Rear axle location
Choosing a middle ratio
A 3.73 ratio is a middle-range choice. It keeps engine rpm moderate at highway speed while giving more pulling force than a lower ratio. Many drivers choose it for a mix of commuting and occasional towing, though the right setting depends on tire size, transmission gearing and how heavily the vehicle is loaded.
Gear sets wear over time, and worn teeth, bearings and carrier parts can cause whine, vibration or temperature rise. A swap is a good moment to inspect the axle shafts, seals and carrier bearings. Keep the first heavy loads moderate until the teeth have seated, and check the gear oil level after the first few drives.
- Compare tire size before settling on the ratio
- Check gear oil for metal flakes during service
- Replace worn carrier bearings with the new set
- Keep the first towing trips light
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2014-373 |
| UPC | 631410105209 |
| Axle type | Ford 7.5 Inches |
| Axle location | Rear |
| Gear ratio | 3.73 |
| Axle manufacturer | Ford |
Vehicle fitment
The set is matched to the Ford 7.5 Inch rear axle. Confirm your housing and carrier type on the vehicle before ordering, since axle type decides fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tooth contact and backlash on a 3.73 set require specialty measurement, so the installation is usually done by a gear shop. A break-in period is needed before heavy towing or hard launches.
What’s included
One ring and pinion set for the Ford 7.5 Inch axle, part number 2-2014-373.
Not included: Bearings, shims and carrier hardware are sold separately and may be needed for the 3.73 set.
















