Overview
The G2 Axle and Gear 4-JK-513 is a 5.13 ratio front and rear ring and pinion kit for non-Rubicon Jeep Wrangler JK models. The JK code in the name places it in the 2007-2018 Wrangler range. The set is built for a Dana 30 front axle and a Dana 44 rear axle, so both ends of the vehicle are covered by the same package.
A 5.13 ratio is a steep gearing choice for this axle pair, with the matched front and rear master installation kits packed alongside the gears. The gears are made from computer heat treated 8620 steel to original equipment specifications.
Key features
- Front and rear 5.13 ratio ring and pinion sets
- Dana 30 front and Dana 44 rear gear sets
- Matched front and rear master installation kits
- Computer heat treated 8620 steel
- Double shot peened and double lapped
- Limited lifetime warranty
Tire size and axle load
A 5.13 ratio is a steep gearing choice that multiplies torque heavily at the wheels, and it reduces road speed at a given engine speed. It suits slow, heavy work and rock crawling. Tire diameter and axle load need to be reviewed against the new ratio, since a heavier setup stresses the gears more.
After the install, drive at low speed and listen for whine under acceleration and on coast. Gears set up incorrectly wear quickly at this ratio, so have pinion depth and backlash checked with the proper gauges. Keep the front and rear master installation kits with their own gear sets throughout the job.
- Review tire size against the new gearing
- Check axle load before heavy trail use
- Re-check fasteners after the first few runs
- Look for leaks at the pinion seal
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-JK-513 |
| UPC | 700007521541 |
| Gear ratio | 5.13 |
| Front axle | Dana 30 JK |
| Rear axle | Dana 44 JK |
| Material | Computer heat treated 8620 steel |
| Models | Non-Rubicon |
| Warranty | Limited lifetime |
Vehicle fitment
The JK chassis code places it in the 2007-2018 Wrangler range. The gear sets are built for a Dana 30 front and Dana 44 rear.
The 2007-2018 range covers the JK generation, so TJ, LJ, YJ and JL Wranglers fall outside it. The kit is made for non-Rubicon models, so Rubicon owners should verify their axle layout before any gears are bought. Match your Wrangler’s year, model and trim to the kit before ordering.
Installation notes
A 5.13 set needs careful pinion depth and backlash setting, and tire size and axle load should be checked against the new ratio before the Wrangler goes back on the road. Keep the front and rear master installation kits with their own gear sets.
What’s included
Front and rear 5.13 ring and pinion sets, plus matched master installation kits for both axles.
Not included: The carriers are sold separately.


















