Overview
The G2 Rear Dana 44 Axle Truss, part 68-2052-1, is a heavy-duty steel truss and armor system for the rear Dana 44 axle of a Jeep Wrangler JK. It is intended for JKs with at least some lift.
The truss runs the length of the whole axle, not only the long tube, and it adds strength in a lightweight design. Main components are 1/4 inch steel and the reinforcement plates are 1/8 inch thick, all laser cut for fit.
Welding is required, including to the cast center section, and professional welding skills are recommended. Vehicles with minimal or no lift need clearances checked before installation. The system is built for US-spec vehicles.
Key features
- Heavy-duty steel construction
- 1/4 inch main components
- 1/8 inch reinforcement plates
- Laser cut for installation
- Covers the full axle
- Unpainted
- Designed for US-spec vehicles
Lift height and clearance
Lift height decides how much room the truss and the axle have to move. On a JK with little or no lift, tires, control arms, brake lines and the driveline can sit closer to the new steel than expected, so measure the gaps before welding. Compare the axle position at full droop and under load to see where contact could happen.
Related parts often get reviewed at the same time. Longer control arms, a taller suspension or larger tires change axle geometry and may need a second look at clearances. Plan any suspension work together, keep the work area clean so welds and fit can be checked properly, and recheck the truss area after the first few trail runs for rubbing or new marks on the steel.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 68-2052-1 |
| UPC | 631410123012 |
| Axle | Rear Dana 44 |
| Fitment | Direct fit; without steering ram mount |
| Material | Heavy-duty steel; 1/4 inch main components, 1/8 inch reinforcement plates |
| Finish | Unpainted |
| Upper link mount | Sold separately, part G/268-2052-2 |
Vehicle fitment
The truss is for the Jeep Wrangler JK, 2007 to 2018, with a rear Dana 44 axle, and it is intended for vehicles with at least some lift.
The Wrangler JL, the TJ and LJ generations, and the Gladiator are not covered. Lower-lift JKs need a clearance check before installation.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check clearances on the axle and driveline before welding, since the manufacturer flags minimal-lift vehicles as needing a closer look.
What’s included
The coil buckets and main axle truss assembly are included.
Not included: the upper link mount, sold separately as part G/268-2052-2.












