Overview
The G2 Rear Dana 44 Coil Buckets, part 68-2052-3, are heavy-duty steel coil buckets for the rear Dana 44 on a JK Wrangler. G2 says they are designed to be used with its rear axle truss and armor system.
The buckets are made from 1/4 inch thick main components and 1/8 inch thick reinforcement plates, and each part is laser cut for installation. Welding is required, and the manufacturer strongly recommends professional welding skills.
Key features
- Heavy-duty steel construction
- 1/4 inch main components and 1/8 inch reinforcement plates
- Laser cut for installation
- Unpainted
- Designed for the G2 rear axle truss system
Choosing the right setup
Coil buckets are the points where the springs sit, so their placement affects ride height, spring alignment and how the axle moves. They work as part of a system with the truss and armor, so the buckets should be matched to the truss they are welded to rather than chosen on their own. Buckets set at the wrong angle put side load on the spring, which can wear coils and mounts faster than expected.
Before ordering, confirm the truss, upper link mount and any steering parts you plan to run, since the buckets are sold without them. Plan the weld sequence with the truss in place, and keep heat away from the armor to limit warp. Coat the steel after welding, because the buckets ship unpainted.
- Match the buckets to the truss they will be welded to
- Plan the weld sequence before cutting
- Check spring seat height at ride height after fitting
- Coat the steel after welding
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 68-2052-3 |
| UPC | 631410123036 |
| Axle | Rear Dana 44 |
| Fitment | Direct fit; without steering ram mount |
| Finish | Unpainted |
| Used with | G2 rear axle truss, part 68-2052-1 |
Vehicle fitment
These coil buckets fit the Jeep Wrangler JK, 2007 to 2018, with a rear Dana 44 axle, in two-door and four-door models.
The Wrangler JL, the TJ and LJ generations, and the Gladiator are not covered for this part.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, and the buckets are meant to be welded as part of the truss install, so plan the weld sequence before cutting.
What’s included
The coil buckets.
Not included: the axle truss assembly and the upper link mount, which are sold separately.







