Overview
The G2 Axle and Gear 68-2050-1 is a top truss for the Dana 30 front axle on the 2007-2018 Jeep Wrangler JK. It is a heavy-duty steel truss and armor system part that must be welded in place, so it suits builders comfortable with fabrication.
The truss strengthens the whole axle, not only the long tube, and its components are laser cut for a close fit. It is designed for US-Spec vehicles. Vehicles with minimal or no lift need clearance checks before installation.
Key features
- Main components are 1/4 inch thick heavy-duty steel
- Reinforcement plates are 1/8 inch thick
- Truss design strengthens the full axle
- Components are laser cut to precise specifications
- Fits 2-door and 4-door models
- Unpainted; welding required, including to the cast center section
Fabrication and weld prep
Welding a truss to a front axle changes how the housing takes loads, so prep matters as much as the weld itself. Clean the paint and mill scale from the contact areas, and dry-fit the pieces before tacking anything. Work slowly so the steel does not warp and the joints line up with the axle tube.
Heat from welding can alter the surrounding metal, so many builders stop between passes to let the area cool and check alignment. After finishing, inspect every bead for cracks, undercut and porosity. A qualified welder can review the joints if the work is outside your experience, since the truss is structural.
- Grind contact surfaces to clean bare metal
- Dry-fit all plates and check clearance
- Tack, then check alignment before full welds
- Inspect the finished welds before off-road use
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 68-2050-1 |
| UPC | 631410123296 |
| Axle | Dana 30 front axle |
| Axle location | Front |
| Steering ram mount | Without steering ram mount |
| Material | Heavy-duty steel |
| Main component thickness | 1/4 inch |
| Reinforcement plate thickness | 1/8 inch |
| Finish | Unpainted |
| Models | 2-door and 4-door |
| Included | Top truss only |
| Fitment | Direct fit |
Vehicle fitment
It is for the 2007-2018 Jeep Wrangler JK with a Dana 30 front axle, in 2-door and 4-door models for US-Spec vehicles. Confirm your model year and axle before ordering.
It is not designed for the Jeep Wrangler JL, the Gladiator, or the earlier TJ, LJ and YJ Wranglers. The Dana 44 rear truss is a separate part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, including to the cast center section, and G2 recommends professional welding skills. For vehicles with minimal or no lift, check clearances before installation. Because the work is structural, have a qualified welder check the welds before the vehicle goes off-road.
What’s included
This part includes the top truss only.
Not included: The rest of the G2 truss and armor system, since this part is the top truss only.













