Overview
The G2 Dana 44 JK Front Reverse 4.88 Ratio Ring and Pinion, part number 2-2051-488R, is a 4.88-ratio gear set for the front Dana 44 axle used in the Jeep Wrangler JK. It is made for a 3.73 and down carrier.
The gears are made from computer heat-treated 8620 steel, double shot peened and double lapped, and they are built to O.E. specifications. A 10-year warranty applies to the set.
Key features
- 4.88 gear ratio in a front reverse design
- For use with a 3.73 and down carrier
- Dana 44 JK front axle
- Computer heat-treated 8620 steel
- Double shot peened and double lapped
Setup and carrier match
A 4.88 ratio gives more pulling power from a stop than a lower-numbered ratio, at the cost of higher engine speed at highway pace. The JK front axle carries the front Dana 44 gear set, so the setup is done on the axle housing under the front of the vehicle. The carrier rating is the main compatibility check, since the carrier must support the ring gear’s load and keep it aligned.
Front axles see steering loads and wheel angles that add stress to the gear mesh, so careful pinion depth and preload work counts. Shops usually check the contact pattern with marking compound and adjust shims until the pattern sits correctly. Tire size changes effective gearing as well, so consider tires and typical loads together.
Carrier bearings, pinion bearings, and the pinion seal are commonly replaced with the gears because the old parts are worn to the previous pattern. After the break-in period, check for metal in the gear oil and listen for whine that changes with load.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2051-488R |
| UPC | 631410094572 |
| Axle type | Dana 44 JK |
| Axle location | Front |
| Gear ratio | 4.88 |
| Carrier | For use with 3.73 and down |
| Warranty | 10 years |
Vehicle fitment
It is for the front Dana 44 axle used across the Jeep Wrangler JK lineup, 2007-2018 model years.
Installation notes
Set the mesh, pinion depth and carrier preload on a front reverse set with the proper tools, then run the gears in before heavy towing.
















