Overview
The G2 Axle and Gear 95-2021-005 is a rear replacement axle shaft for the GM 10 bolt 8.5 inch axle in the 1988–1991 GM Blazer two-wheel-drive non-IFS. It has 30 splines and a 31.31 inch overall length.
It can be fitted on the driver or passenger side. It is forged from high grade alloy steel and heat treated.
The 95-2021-005 is made for the two-wheel-drive Blazer without independent front suspension. It has 30 splines and a 31.31 inch overall length, and fits either side of the GM 10 bolt 8.5 inch rear axle. The steel is forged and heat treated.
Key features
- 30 splines
- 31.31 inch overall length
- Either driver or passenger side
- 2WD non-IFS Blazer
- GM 10 bolt 8.5 inch rear axle
- Wheel studs not included
Two-wheel drive versus four-wheel drive
Blazers from this period came in two-wheel and four-wheel drive, and the shaft layout and axle housing differ between them. Before buying, confirm the drivetrain and the front suspension type, since an axle that suits a non-IFS two-wheel-drive truck will not fit a four-wheel-drive version. Check the transfer case and front axle on your truck to be certain.
On a two-wheel-drive Blazer the rear axle carries the drive load on its own, so the shaft sees steady torque from the transmission and loads from every bump. Replace the bearing and seal when the shaft is out, check the brake backing plate and inspect the wheel studs for cracks or thread damage. Keep the rear brakes adjusted, and check for leaks from the housing after the first few drives.
- Confirm two-wheel drive before ordering
- Check the front suspension type on your truck
- Inspect the wheel studs for cracks or thread damage
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2021-005 |
| UPC | 631410106053 |
| Product type | Replacement axle shaft |
| Axle type | GM 10 Bolt 8.5 inch |
| Axle location | Rear |
| Shaft position | Driver Or Passenger |
| Spline count | 30 |
| Overall length | 31.31 inches |
| Wheel studs | Not included |
| Stated application | 1988-1991 GM Blazer 2 WD Non IFS |
Vehicle fitment
It fits the 1988–1991 Chevrolet Blazer.
It is for two-wheel-drive Blazers without independent front suspension. Confirm your vehicle’s year, model and trim, and confirm two-wheel drive, before ordering.
Installation notes
- Confirm that your Blazer is two-wheel drive before you fit the shaft.
- Studs are not included.
What’s included
One rear axle shaft that fits either side (95-2021-005).
Not included: wheel studs for the 95-2021-005.








