Overview
The G2 Axle and Gear 95-2013-004 is a rear driver-side replacement axle shaft for the Ford 8.8 inch axle, made for the 1987–1996 Ford F-150 and Bronco. It has 31 splines and is set up for 1/2 inch press-fit wheel studs.
G2 Axle and Gear builds its replacement shafts for owners who have outgrown the factory part. The company says its shafts are forged from high grade alloy steel, heat treated beyond OEM specifications and engineered for the added load of high-torque use, so a bigger tire is less likely to break one.
A driver-side rear shaft like the 95-2013-004 is the part to look at when a factory shaft has failed or when bigger tires and more power are on the way. G2 Axle and Gear points to rolled splines and Big Spline options across its range as the way it lets owners run larger tires with confidence. Before ordering, compare the 31-spline count, the 1/2 inch stud size and the driver-side position with the shaft you are replacing.
Key features
- Fits the rear Ford 8.8 inch axle on the driver side
- 31-spline shaft
- Accepts 1/2 inch press-fit wheel studs
- Forged alloy steel and heat treated.
- Built as a stronger alternative to the factory shaft
- Wheel studs are not included
Tire size and shaft load
Larger tires raise the torque and shock load on each axle shaft, and the weakest points are usually the spline ends and the flange where the press fit studs sit. Before choosing a replacement, count the splines on your existing side gears and confirm they match the 31-spline count. Gear ratio, tire diameter and how hard the truck is driven all change the load, so a shaft that held up on stock tires may not hold up on a larger set.
Replacement shafts are often swapped together with the axle bearings and seals when the differential is opened, because a failed shaft can damage a bearing. Look for a bent flange, cracked splines, grease on the inside of the wheel and a wobble at the wheel. Check the axle seal on the same side, since a leak can dry out the bearing. Keep a torque wrench on hand for the wheel and axle nuts.
- Count the side gear splines before ordering
- Check the bearing and seal on the same side
- Inspect the flange for bending or cracks
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2013-004 |
| UPC | 631410105735 |
| Product type | Replacement axle shaft |
| Axle type | Ford 8.8 inch |
| Axle location | Rear |
| Shaft position | Driver Side |
| Spline count | 31 |
| Press-fit wheel stud size | 1/2 inch |
| Wheel studs | Not included |
| Stated application | 1987-1996 Ford F-150 / Bronco / E-150 driver side |
Vehicle fitment
It fits the 1987–1996 Ford Bronco and the 1987–1996 Ford F-150.
G2’s own wording also mentions the E-150 van, but the van does not appear in the vehicle list, so check it with G2 before using it for that application. Other generations of the F-150 and Bronco are not covered by these dates. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Press-fit studs are pressed into the flange, and you will need to supply 1/2 inch studs because none come with the shaft.
- The 31-spline count must match the side gear in the differential of your 8.8 inch axle.
What’s included
One driver-side rear axle shaft (95-2013-004).
Not included: wheel studs for the 95-2013-004.






