Overview
The G2 Axle and Gear 95-2021-003 is a rear replacement axle shaft for the GM 10 bolt 8.5 inch axle, made for the 1988–1991 GM K10 four-wheel-drive truck without independent front suspension. It has 30 splines and a 31.31 inch overall length.
Forged from high grade alloy steel and heat treated beyond OEM specifications, the shaft fits either the driver or passenger side of the rear axle.
This is a non-IFS shaft, built for four-wheel-drive trucks with a solid front axle rather than independent front suspension. Its 30 splines and 31.31 inch overall length make it straightforward to compare against the old shaft during removal. The steel is heat treated for longer service life under load.
Key features
- 30 splines
- 31.31 inch overall length
- Either driver or passenger side
- Non-IFS 4WD application
- GM 10 bolt 8.5 inch rear axle
- Wheel studs not included
Checking the old axle shaft
Before removing the original shaft, look at the axle housing and the seal behind the flange. Oil on the inside of the wheel usually points to a leaking seal, and a leaking seal can contaminate the bearing on a new shaft if it is not addressed during the job. Note whether the old shaft is bent or shows cracked or rounded splines, since that wear often shows up in the drivetrain before it is visible from underneath.
Wheel studs are not supplied, so have them on hand before the job starts. Many people replace the wheel bearing and seal together when the axle is already open, because the labor overlaps and a fresh seal protects the new shaft from dirt and moisture.
- Clean the flange and check it for damage before fitting
- Look for grease or oil leaks at the housing
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2021-003 |
| UPC | 631410106039 |
| Product type | Replacement axle shaft |
| Axle type | GM 10 Bolt 8.5 inch |
| Axle location | Rear |
| Shaft position | Driver Or Passenger |
| Spline count | 30 |
| Overall length | 31.31 inches |
| Wheel studs | Not included |
| Stated application | 1988-1991 GM K10 4 WD Non IFS |
Vehicle fitment
It fits the 1988–1991 Chevrolet Blazer.
G2’s description specifies non-IFS trucks, meaning those without independent front suspension, and the list names the Blazer only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Confirm the truck has a solid front axle before fitting this non-IFS shaft.
- Wheel studs have to be supplied.
What’s included
One rear axle shaft that fits either side (95-2021-003).
Not included: wheel studs for the 95-2021-003.











