Overview
The G2 Axle and Gear 96-2025-2 is an AMC 20 rear chromoly one-piece axle kit with 29 splines and a 5-lug pattern. It is for 1976-1981 Quadratrac Jeep CJ models.
G2 Axle and Gear says its axle kits are made from high-tensile alloy steels that are forged and heat treated for strength, and that the larger diameter of Big Spline shafts lets them withstand much higher torsional loads than the stock diameter, so the axle shafts stop being the weakest point of the driveline. Shaft and gear set engage through splines, so the 29-spline 96-2025-2 calls for a matching 29-spline differential or carrier. G2 names the Quadratrac setup in the application note for the 96-2025-2, so owners should read that note closely and confirm their CJ is a Quadratrac model before choosing this AMC 20 kit.
Key features
- Rear axle kit for the AMC 20
- 29 spline, 5-lug, one-piece axle design
- Includes wheel bearings
- Includes wheel studs
- Includes retainer plates with seals
- Made from high tensile alloy steel, forged and heat treated.
- Fits 76-81 Quadratrac CJ models
- Axle: AMC 20 rear
Before you replace the axle
A one-piece axle carries the wheel load and the drive torque through a single shaft, so the condition of the housing, bearings and seals matters as much as the shaft itself. Before installing a new shaft, inspect the axle tube for leaks, check the brake components that share the hub, and make sure the mounting surfaces are clean and undamaged.
Because the shaft and differential engage through splines, the spline count and length must match the original setup. Measure the old shaft and compare it with the new one before disassembly. Replacing the wheel studs and bearings during the same job keeps the hub assembly consistent and avoids reopening the axle soon after.
- Inspect the axle tube and seals for leaks
- Check brake parts that share the hub
- Measure the old shaft before disassembly
Specifications
The 96-2025-2 is a rear one-piece axle kit for the AMC 20 rear axle, with 29 splines. Every figure in the table below is the manufacturer value for the 96-2025-2.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 96-2025-2 |
| UPC | 631410096866 |
| Part type | Rear one-piece axle kit |
| Axle | AMC 20 rear |
| Spline | 29 spline |
| Lug pattern | 5-lug |
| Construction | 1-piece axle kit |
| Differential | None included |
| Application stated | 76-81 Quadratrac CJ |
Vehicle fitment
No vehicle year or model list is published for the 96-2025-2; check the manufacturer specifications for the exact application.
The application for the 96-2025-2 is 76-81 Quadratrac CJ.
Check the old shaft’s spline count and length against the 96-2025-2 specifications before you start the job.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit is for Quadratrac CJ models and includes wheel studs, bearings and retainer plates with seals, so the original shafts and bearings are replaced as a set.
What’s included
- Wheel bearings
- Wheel studs
- Retainer plates with seals
- One-piece axle shafts







