Overview
The G2 Dana 44 Chromalloy inner axle shaft, part 97-2033-010, is a passenger side front inner shaft with 30 splines for Dana 44 front axles. It fits the 1974–1979 Jeep Wagoneer.
G2 Axle and Gear forges the shaft from high-grade alloy steel and heat treats it to exceed OEM specifications, aiming at the weak points G2 says are common in factory shafts. The forging is built for high-torque use and the added load of larger tires. Match the 14.690 inch overall length and the 5-760X U-joint connection before you order.
Key features
- Forged from high-grade alloy steel and heat treated to exceed OEM specifications
- 30-spline inner end on the passenger side of a front Dana 44
- Accepts a 5-760X U-joint
- Machined to take full circle clips
- 14.690 inch overall length
- It is designed to handle the added load of larger tires and high-torque use.
Inner shaft wear signs
An inner axle shaft carries drive torque from the differential out to the U-joint, so it takes a twisting load every time the vehicle moves under power. On a front axle that load rises with heavier tires, aggressive trail use and towing. Spline wear is usually the first sign of trouble. Look for rounded or chipped teeth, a loose fit in the differential side gear, or a clunk when the drivetrain is loaded and released.
Use the shaft replacement as a chance to inspect the U-joint, clips and inner seal. A worn U-joint sends shock into the shaft and can break a new part early. A leaking seal lets gear oil reach the brake area and lets dirt into the differential. Replacing the clips and seal in the same job saves a second teardown, and checking the seal after the first drive shows whether the install is sound.
- Check spline teeth for rounding, cracks or chips
- Inspect the U-joint before reassembly
- Replace clips and seals during the same job
- Look for gear oil at the inner seal after the first drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2033-010 |
| UPC | 631410097214 |
| Axle type | Dana 44 |
| Axle location | Front |
| Shaft location | Passenger side, inner |
| Spline count | 30 splines |
| Overall length | 14.690 inches |
| U-joint | 5-760X |
| Clip style | Machined for full circle clips |
| Material | Forged high-grade alloy steel, heat treated |
Vehicle fitment
It fits the 1974–1979 Jeep Wagoneer (SJ) in the front axle position. Confirm fit for your vehicle’s year, model and trim before ordering.
Wagoneer years outside 1974–1979 are not covered by that statement. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a passenger side inner shaft, so confirm the side before you fit it. The shaft is machined for full circle clips, so the clip style at the axle end has to match.
What’s included
One inner axle shaft.
Not included: U-joint, clips, bearings and seals.







