Overview
The G2 Axle and Gear 2-2021-538 is a 5.38 ratio ring and pinion for GM 10 Bolt 8.5 inch axles. The pinion turns 5.38 times for each ring gear turn, so it multiplies torque more than the numerically lower sets do.
The set fits 8.5 inch and 8.6 inch 10 Bolt ring gears in both front and rear locations. Its line aims at oversized tires and high-performance builds. Vehicle models and years are not identified, so confirm the ring diameter and axle location before buying.
Key features
- 5.38 gear ratio for GM 10 Bolt 8.5 inch axles
- Covers 8.5 inch and 8.6 inch ring gear housings
- Fits front and rear axle locations.
- Ring gear and pinion supplied as a matched set
- Made for oversized tires and high-performance engines.
Trail and road use
A 5.38 ratio puts more pull into each wheel at low speed, which helps when hauling, climbing or crawling. The trade-off is engine speed: at highway speed the motor turns faster, which can add noise and fuel use. Tire diameter changes the effect, so larger tires partly offset a numerically high gear.
Before committing, look at the transmission and transfer case gearing, the tire size and how the vehicle is driven most often. The axle is only one part of the drivetrain, and a gear change can feel mismatched if the other parts are ignored. Plan a few test drives after the swap to check temperature, noise and shift behavior under load.
- Check tire diameter before choosing gears
- Review transmission and transfer case ratios
- Plan a break-in drive after setup
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2021-538 |
| UPC | 631410105605 |
| Axle type | GM 10 Bolt, 8.5 inch or 8.6 inch ring gear |
| Axle location | Front or rear |
| Gear ratio | 5.38 |
| Axle manufacturer | GM |
Vehicle fitment
Fitment is not tied to specific vehicles. The 5.38 set fits GM 10 Bolt 8.5 inch and 8.6 inch axles, front or rear, so verify those on your vehicle. Axles outside that range need their own fit check before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 5.38 set needs careful tooth contact setup, so a gear shop with setup tools is the practical installer. Plan for a break-in run before sustained towing.
What’s included
One 5.38 ring and pinion set for GM 10 Bolt 8.5 inch axles, part number 2-2021-538.
Not included: Bearings, shims and install hardware are outside this kit and may need to be bought separately.
















