Overview
The G2 Axle and Gear 2-2029-410 is a 4.10 ratio ring and pinion for the Chrysler 8.25 inch rear axle. It is made for carriers rated 2.56 or higher, so the carrier should be at least 2.56 before the gears are installed.
G2 describes its performance gear sets as built for oversized tires and high performance engines. The 4.10 gears are made from computer heat treated 8620 steel and finished with double shot peened and double lapped surfaces.
Key features
- 4.10 ratio rear ring and pinion
- Chrysler 8.25 inch rear axle
- For use on 2.56 and up carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Carrier and housing checks
A carrier rating matters because the ring gear and pinion load the carrier housing, bearings and case bolts every time the axle turns under throttle. A carrier that is too light for the gear set can flex, which changes the mesh and leads to noise or early tooth wear. Before buying, measure the existing carrier, confirm its rating, and compare it with the axle housing on the vehicle.
Setup matters as much as the parts. Pinion depth sets where the gears meet, backlash sets the small clearance between teeth, and preload sets bearing tightness. These are usually checked with a dial indicator and a contact pattern test. Replacing the carrier bearings and pinion seal at the same time keeps the new set from settling into worn parts.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2029-410 |
| UPC | 631410093827 |
| Gear ratio | 4.10 |
| Axle location | Rear |
| Axle type | Chrysler 8.25 inch |
| Popular axle manufacturer | Chrysler |
| Carrier requirement | 2.56 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It fits the Chrysler 8.25 inch rear axle at a 4.10 ratio. Make sure your housing is this size and that the carrier rating is 2.56 or higher.
Only the Chrysler 8.25 inch is named for this 4.10 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the 8.25 inch Chrysler gears should be set by a driveline shop, with a break-in period afterward.
What’s included
A matched ring and pinion for the Chrysler 8.25 inch rear axle.














