Overview
The G2 2-2034-538 is a 5.38 ratio ring and pinion for the Dana 60 axle. It fits both front and rear Dana 60 locations and needs a carrier rated at 4.56 or higher, so the carrier ratio must be at or above that class.
G2 describes its gear sets as made for oversized tires and high performance engines. This 5.38 Dana 60 set uses computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- 5.38 ratio Dana 60 ring and pinion
- Fits front and rear locations
- For use with 4.56 and up carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Heavy-duty axle gearing
The Dana 60 is a heavy axle, and gears in this class carry large torque loads through the ring gear teeth and pinion. Gear sets at a 5.38 ratio are often chosen for steep grades, deep mud and slow crawling with big tires, where low gearing keeps the engine in its torque band.
Regear jobs on a Dana 60 usually involve more than the gears. Pinion bearings, the crush sleeve, carrier bearings and axle seals are commonly replaced at the same time. Look for wear on the old ring gear teeth, such as chipping or uneven contact, since that points to a problem worth fixing before new gears go in.
Plan the job around how the truck will be used, and keep notes on the setup for later service.
- Match the carrier to the ratio before buying
- Check axle seals for leaks after the first trail trip
- Recheck carrier cap bolts after break-in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-538 |
| UPC | 69823101127 |
| Gear ratio | 5.38 |
| Axle location | Front and rear |
| Axle type | Dana 60 |
| Popular axle manufacturer | Dana |
| Carrier requirement | 4.56 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
The set is a 5.38 ratio for the Dana 60 axle, in both front and rear positions. Confirm the axle position and carrier before ordering.
It fits the Dana 60 only, not other Dana axle sizes. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Dana 60 gears need pinion depth, backlash and bearing preload set by a driveline shop, followed by a break-in period on the 5.38 ratio.
What’s included
A matched ring and pinion for the Dana 60 axle.













