Overview
The G2 Axle and Gear 1-2095-342 is a 3.42 ratio O.E.M. series ring and pinion for the GM 8.25 inch IFS front axle. It fits the front location and is matched by axle type.
Built under contract with original equipment manufacturers, these gears are meant to run cooler and quieter than aftermarket options. Because the ratio is 3.42, torque multiplication at the wheels is lower than with a 3.73 set.
Key features
- O.E.M. series 3.42 ring and pinion
- GM 8.25 inch IFS front axle type
- Front axle location
- Made under contract with original equipment manufacturers.
- Built to run cooler and quieter than aftermarket gears.
Matching front and rear gears
Front and rear ratios work as a pair. A front differential geared differently from the rear can cause binding in four-wheel drive and uneven tire wear, so the 3.42 choice should be checked against the rear ratio and transfer case behavior. Tire size changes the effective ratio too, so measure the diameter before deciding.
Front IFS gears need careful setup because the carrier sits in a tight space and carries steering loads. Carrier bearings and pinion seals are easy to disturb during a gear change, and they are good candidates for replacement at the same time. Inspect the axle shaft boots and seals for cracks, and watch for leaks after the first few drives. Fresh gear oil at the correct level helps the new surfaces wear in evenly.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2095-342 |
| UPC | 631410093087 |
| Gear ratio | 3.42 |
| Axle location | Front |
| Axle type | GM 8.25 inch IFS |
| Popular axle manufacturer | GM |
| Series | O.E.M. |
Vehicle fitment
This 3.42 set is matched to the GM 8.25 inch IFS axle. Confirm the axle type before ordering.
Only the GM 8.25 inch IFS is named for this 3.42 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the 8.25 inch IFS 3.42 gears should be set by a driveline shop before the front axle goes into service.
What’s included
A matched O.E.M. series ring and pinion for the 8.25 inch IFS front axle.
















