Overview
The G2 Axle and Gear 4-YJ-456 is a front and rear ring and pinion kit with a 4.56 ratio, built around a Dana 30 front axle and a Dana 35 rear axle. Confirm your vehicle’s year, model and trim before choosing it.
The 4.56 ratio is a common step for Jeeps running taller tires, since shorter gearing brings back some of the pulling power that larger tires take away. The kit includes the front and rear sets together with a matched Master Installation Kit for each axle. The steel is computer heat treated 8620 that is double shot peened and double lapped.
G2 backs these gear sets with a limited lifetime warranty and says they are made to O.E. specifications. The kit comes as a full front-and-rear package rather than a single axle set.
Key features
- 4.56 ratio, front and rear
- Dana 30 front axle and Dana 35 rear axle
- Two matched Master Installation Kits, one per axle
- 8620 steel, computer heat treated
- Double shot peened and double lapped
- Manufactured to O.E. specifications
- Limited lifetime warranty from G2
Choosing a gear ratio
Gear ratio is a trade between pulling power and cruising speed. Shorter, numerically higher ratios help a Jeep climb and crawl with larger tires, while taller ratios suit highway driving with stock tires. When a front and rear pair is changed together, both differentials should share the same ratio so the driveline stays balanced.
Pick a ratio after looking at how the Jeep is used most of the time. A trail rig with oversized tires usually gains from a lower gear, while a mostly paved Jeep may not need the change. Keep the old gears and paperwork until the new set is proven, and plan for setup work on both axles after installation.
- Measure your current tire diameter
- Decide whether the Jeep is mostly trail or highway
- Plan for setup work on both axles
- Store the old gears until the change is proven
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-YJ-456 |
| UPC | 700007521661 |
| Gear ratio | 4.56 |
| Front axle | Dana 30 Reverse |
| Rear axle | Dana 35 |
| Axle location | Front and rear |
| Material | Computer heat treated 8620 steel |
| Finishing | Double shot peened, double lapped |
| Warranty | Limited lifetime (G2) |
Check the package contents against your installation before starting.
Vehicle fitment
No vehicle list from G2 accompanies the 4-YJ-456. The kit is named for the YJ, but its feature list refers to the 1984 to 1999 XJ Cherokee, and the attributes name the front axle as Dana 30 Reverse.
Until G2 clarifies, rely on the axle pair: Dana 30 Reverse up front, Dana 35 at the rear. If your Jeep has different axles, this kit is not meant for it.
Not confirmed: a specific vehicle or year range. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 4.56 swap changes both differentials, so pinion depth and backlash must be set on each and the contact pattern checked. A professional gear setup is the common route, and the new gears should be run gently at first.
Because the installation kits are matched to the front and rear gear sets, install the front and rear sets as a pair.
What’s included
- Front ring and pinion set, 4.56
- Rear ring and pinion set, 4.56
- Front Master Installation Kit
- Rear Master Installation Kit
Not included: gear oil and other related parts.


















