Overview
The G2 Axle and Gear 2-2044-488 is a 4.88 ratio ring and pinion for the Toyota 9.5 inch axle, fitted to Toyota Land Cruiser applications. It fits front and rear locations and works with all ratio carriers.
G2 describes its gear sets as engineered for oversized tires and high performance engines. This 4.88 set is made from computer heat treated 8620 steel with double shot peened and double lapped surfaces, to O.E. specifications.
Key features
- 4.88 ratio ring and pinion
- Toyota 9.5 inch axle
- Named with the Toyota Land Cruiser
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Choosing a gear ratio
A ring and pinion sets the final drive ratio between the driveshaft and the axle shafts. A numerically higher ratio such as this 4.88 set multiplies torque more at the wheels, which helps with heavy tires, steep grades and low-speed crawling. The trade-off is higher engine speed at highway cruising, so gearing choices should match how the vehicle is driven most of the time.
Gears of this kind are normally replaced as a matched set. The ring and pinion must be paired with the correct carrier and bearings, and the pinion depth and backlash should be checked after any change. Installers often replace the carrier bearings and pinion seal at the same time, since the axle is already open.
- Confirm the axle is a Toyota 9.5 inch before buying
- Replace the pinion seal during the gear swap
- Re-check backlash after the first few trail runs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2044-488 |
| UPC | 631410094411 |
| Gear ratio | 4.88 |
| Axle location | Front and rear |
| Axle type | Toyota 9.5 inch |
| Popular axle manufacturer | Toyota |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is made for the Toyota 9.5 inch axle at a 4.88 ratio. Confirm the year and axle before ordering.
Only the Toyota 9.5 inch is named for this 4.88 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A driveline shop should set pinion depth, backlash and bearing preload on the 9.5 inch Toyota gears, then complete a break-in period on the 4.88 ratio.
What’s included
A matched ring and pinion for the Toyota 9.5 inch axle.
















