Overview
The G2 Axle and Gear 35-2017 is a master ring and pinion installation kit for GM 8-inch IFS front axles. It includes the bearings, shims and seal needed to install a new ring and pinion. The gear set is not part of the kit.
Front and rear gear sets follow the same basic procedure but differ in size, so confirm the axle position before you start.
Key features
- Pinion and carrier bearings with races for a complete bearing set
- Shim kit for pinion and carrier setup
- Pinion seal and crush sleeve
- Ring gear bolts, Loctite, gear marking compound and silicone sealer
Front axle setup precautions
A GM 8-inch IFS front differential sits behind the front axle shafts, so access to the carrier is limited and the pinion runs at a different angle than a rear axle. Work through the axle removal carefully, and label the bearing caps and shims so each piece goes back in its original position. Shims chosen for one carrier should not be moved to another carrier.
Gear wear shows up as chipped teeth, pitting, or a whine that changes with throttle and coast. When any of those are present, the gear set and bearings should be replaced together. Clean the housing thoroughly and check the drain plug and breather before filling with fresh lubricant.
- Label bearing caps and shim packs by position
- Inspect the carrier bore for scoring
- Replace bearings and gear set as one job
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2017 |
| UPC | 631410095623 |
| Axle type | GM 8 Inches |
| Axle location | Front |
| Popular axle manufacturer | GM |
| Kit type | Master kit with bearings |
Vehicle fitment
Fit is by axle only: GM 8-inch IFS front axles. Check your vehicle’s year and model before ordering.
Confirm the axle position and ring gear size on your vehicle before ordering this kit.
Installation notes
IFS front gear sets are usually a shop job: pinion preload, carrier shim selection and tooth contact all have to be set and checked, and the new gears need a break-in period. Support the vehicle on stands rated for its weight before any front axle work.
What’s included
The kit includes the pinion and carrier bearings with races, the shim kit, pinion nut, pinion seal, crush sleeve, ring gear bolts, Loctite, gear marking compound and silicone sealer.
Not included: the ring and pinion gear set.











