Overview
This is a 4.10 ratio O.E.M. series ring and pinion for GM 10 bolt 8.5 inch and 8.6 inch axles. It fits front and rear locations and works with 2.73 and up carriers.
The O.E.M. series is designed to run cooler and quieter than aftermarket gears. The gears are made under contract with original equipment manufacturers. The 8.6 inch version works with the 35-2022 Master Kit.
Key features
- O.E.M. series gear set
- 4.10 ratio for 2.73 and up carriers
- Front and rear locations listed
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Choosing a gear ratio
A 4.10 ratio is a common step up for GM 10 bolt axles when the vehicle runs larger tires or pulls a trailer. A numerically higher ratio helps low-speed pulling and engine response, while highway speeds will run at higher RPM. The right ratio depends on tire size and how the vehicle is used.
Ring and pinion work is a good time to check the rest of the axle. Pinion bearings, carrier bearings, and the pinion crush sleeve are often replaced with the gears. Check the 8.6 inch housing for wear and confirm the Master Kit parts are on hand before starting the job.
- Confirm the carrier ratio before ordering
- Replace worn bearings and seals together
- Recheck pinion depth after the first drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2021-410 |
| UPC | 631410092820 |
| Gear ratio | 4.10 |
| Axle location | Front and rear |
| Axle type | GM 10 bolt 8.5 inch and 8.6 inch |
| Popular axle manufacturer | GM |
| Carrier requirement | 2.73 and up |
| Series | O.E.M. |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It fits GM 10 bolt 8.5 inch and 8.6 inch axles at a 4.10 ratio. Confirm the housing size and carrier before ordering.
Check the axle size against your vehicle before ordering, since this set is sized for the 8.5 inch and 8.6 inch housings.
Installation notes
The 8.6 inch version works with the 35-2022 Master Kit, and pinion depth and backlash should be set by a driveline shop before the axle is put into service.
What’s included
A matched O.E.M. series ring and pinion for the 4.10 ratio.
Not included: the 35-2022 Master Kit.












