Overview
The G2 2-2095-488 is a 4.88 ratio ring and pinion for the GM 8.25 inch IFS front axle. It fits the front location and works with all ratio carriers, so any carrier that matches the gear design can be used.
G2 says these performance gear sets are engineered for oversized tires and high performance engines. This IFS set is made from computer heat treated 8620 steel, with double shot peened and double lapped surfaces.
Key features
- 4.88 ratio front ring and pinion
- GM 8.25 inch IFS front axle
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Front axle gearing on IFS
On an independent front suspension, the ring gear sits in a carrier that also moves with the steering and suspension. That makes pinion setup more sensitive to shims and bearing preload than on a solid axle. Setting the mesh correctly matters for quiet running and long gear life.
Front gear changes often come with higher steering loads and different wheel speeds at the front, so the front driveline sees different stress than the rear. Inspect CV joints, axle shafts and front differential fluid at the same time, and replace worn parts before the new gears are loaded.
A careful setup and a short break-in make the first months of use far more predictable.
- Verify tire diameter before selecting a ratio
- Check front differential fluid after installation
- Inspect CV joints for wear during the job
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2095-488 |
| UPC | 631410112689 |
| Gear ratio | 4.88 |
| Axle location | Front |
| Axle type | GM 8.25 inch IFS |
| Popular axle manufacturer | GM |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
The set covers the GM 8.25 inch IFS at a 4.88 ratio. Confirm the axle type before ordering.
Only the GM 8.25 inch IFS is named for this 4.88 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
On an IFS front axle, a driveline shop should set pinion depth, backlash and bearing preload on the 4.88 gears before a break-in period.
What’s included
A matched ring and pinion for the GM 8.25 inch IFS front axle.














