Overview
The G2 Axle and Gear 3-2011-620 is a 6.20 ratio ring and pinion for the rear Ford 9 Inch axle. In this set the pinion turns 6.20 times for every ring gear revolution, a numerically high ratio that multiplies torque at the wheels and suits larger tires.
G2’s Performance Ring and Pinion sets are made for oversized tires and high-performance engines. This 6.20 set is made for the rear Ford 9 Inch axle. Verify the housing and carrier on your vehicle before buying.
Key features
- 6.20 gear ratio for the Ford 9 Inch rear axle
- Rear axle location
- Ring gear and pinion supplied as one matched set
- Built for oversized tires and high-performance engines.
- Made with current manufacturing methods.
Steep ratios and tire size
The 6.20 ratio is a steep option for the Ford 9 Inch rear axle. It multiplies torque at the wheels, which helps with heavy loads and larger tires. The trade-off is higher engine rpm at highway speed, along with more heat and noise on long drives. Plan the ratio around how the vehicle is used most of the time.
Tire size and ratio work together. Larger tires lower the effective gearing, so a steep set can restore low-speed pulling. Check the speedometer after changing both tires and gears, because the readings will shift and the new numbers should be known before long trips.
Good setup protects the new gears. Pinion depth, backlash and preload must be right, or the set will whine and wear early. Replace carrier bearings and the pinion seal during the same job, and check the differential fluid for metal after the first few drives. Listen for noise under light throttle and on coast.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 3-2011-620 |
| UPC | 631410107272 |
| Axle type | Ford 9 Inches |
| Axle location | Rear |
| Gear ratio | 6.20 |
| Axle manufacturer | Ford |
Vehicle fitment
This 6.20 set is made for the rear Ford 9 Inch axle. Confirm that housing and its carrier on your vehicle before buying, along with your vehicle’s year, model and trim.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tooth contact, backlash and carrier preload on a 6.20 set need measured setup, so a gear shop is the usual choice. Allow a break-in period before heavy loads.
What’s included
One 6.20 ring and pinion set for the rear Ford 9 Inch axle, part number 3-2011-620.
Not included: Carrier bearings and shims.
















